AC11 - Instructions

Took out burner (pulls out) Took out one screw that holds recep. in, cut the two old wires and attached new wires with wire nuts included in the new package.

Pulled out the old, plugged in the new

dissembled the burner, remove the broken blocpk and bad spade.rewiered and assembled the burner.

just replaced by hand .

Pulled out the old burners and put in the new ones.

remove burned out eye, replaced with new eye.new eye does not fit exactally correct onto splash pan as point on end of steel " rod " not pointed enough to slip into mate on splash pan

Removed old element, plugged in new one, tested ok

new element plugged into burner connection- an easy fix

All I had to do was remove the old burner and push the new burner into place. It couldn't have been easier.

The repairs were very simple we just disconnected one screw then removed the old one and replace with new one. The left side took a little longer, because of the 8 screws we needed to remove to take the back panel off. But once we had it taken off the replacement was a snap. Nothing to it.

so easy, just ordered the part, the part came and inserted the element into the stovetop

Pulled out the old burner and plugged in the new!

No brain surgery required. Removed electric burner, put in new drip pans. Voila! Good for many more years of service looking like new.

I removed the old element. I then plugged the new element in place. Simple repair, no tools required. Turned the cooktop element on to test for proper functioning. It heated properly. Repair completed.
Ordering the part was easy and it arrived within 2 days. Very happy with Parts Select service.

Replaced the drip pans