999L30XG Kenmore Dryer - Parts

If your gas dryer is not heating up or igniting, then replacing the flame sensor, located in the burner assembly, could solve it. This part senses heat from the igniter to monitor if it is hot enough to ignite gas to light the burner. Once the igniter is hot enough it will open the valve and allow gas to flow. This is a safety mechanism t...Read moreo prevent dangerous levels of gas from building up. To repair, the main top of the dryer should be lifted, as well as the front panel to access the component. This flame sensor assembly is made of both plastic and metal.

This screw is sold individually.

This 'K' series ignition coil kit contains three coils - one secondary coil, one holding coil, and one booster coil. The holding coil sits on top of the booster coil on the same post. If the igniter glows but there is little to no flame or your clothes won't dry, then you have to replace these coils.

This igniter can only be used in place of round style igniters. This part ignites the gas within the dryer.

This gas valve ignition coil kit is made for use with Amana/Speed Queen brand Rodger style gas clothes dryers. It comes complete with a wire harness connector and seals.