999L30XG Kenmore Dryer - Overview

Diagrams for 999L30XG

See every part. Know exactly what you need.

Parts for the 999L30XG

$35.80

Dryer Radiant Flame Sensor

★★★★★

(12)

Part #WP338906

If your gas dryer is not heating up or igniting, then replacing the flame sensor, located in the burner assembly, could solve it. This part senses heat from the igniter to monitor if it is hot enough to ignite gas to light the burner. Once the igniter is hot enough it will open the valve and allow gas to flow. This is a safety mechanism t...Read more

Read less

$7.47

Washer Screw 818 X 1/2

Part #WP3390631

This screw is sold individually.

K-Series Ignition Coil Kit

★★★★★

(4)

Part #12001348

This 'K' series ignition coil kit contains three coils - one secondary coil, one holding coil, and one booster coil. The holding coil sits on top of the booster coil on the same post. If the igniter glows but there is little to no flame or your clothes won't dry, then you have to replace these coils.

Ignitor

Part #WP4392003

This igniter can only be used in place of round style igniters. This part ignites the gas within the dryer.

$74.08

Booster Coil

Part #WP305605

'K' Series Ignition Coil Kit

Part #56225A

This gas valve ignition coil kit is made for use with Amana/Speed Queen brand Rodger style gas clothes dryers. It comes complete with a wire harness connector and seals.

Switch

Part #M400944

DISCONTINUED

Part #91030

LOCKWASHER

Part #M400014

SHUT-OFF VALVE

Part #M406102

DISCONTINUED

Part #M401930

PLUG,BLOCK-OPEN

Part #53390

Common Symptoms of the 999L30XG

How this model fails, and the parts that fix it.

Not Heating

Fixed by
these parts

Show All

Videos related to the 999L30XG

Watch our pros, then fix it yourself.

Replacing the Dryer Radiant Flame Sensor

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Gas Flame Would Drop Out

49 of 66 people found this instruction helpful.

FRED from BRIELLE, NJ
A Bit Difficult
15 - 30 mins
Nutdriver, Screw drivers

First it was a process of alimination to find out why it was dropping out. After the problem was found it was just a matter of replacing the holding coil on the gas valve. Thank you fred kenney sr

Was this helpful?

Dryer would not heat up.

26 of 30 people found this instruction helpful.

Roger from Bonners Ferry, ID
Really Easy
Less than 15 mins
Nutdriver, Screw drivers

I unplugged the dryer,removed the two small screws on the front of the dryer and pulled the bottom forward. The two wires connected to the door do not have to be removed. With an electrical tester using the Ohm setting I tested the Radiant sensor and the Gas Valve coils. The two terminal coil was DOA. The dryer can be operated with the f ... Read more

Read less

Was this helpful?

Dyer would not heat, flame would shut off within 10 seconds

24 of 29 people found this instruction helpful.

Christy from Riley, MI
Easy
Less than 15 mins
Screw drivers, Socket set

I opened the panel, undid the plugs, detached the radiant sensor by undoing one screw and removed and replaced the part. Fairly simply.

Was this helpful?