911619 Kenmore Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The light inside the oven had burned out
3 of 7 people
found this instruction helpful.
-
Catherine from SEATTLE, WA
- Very Easy
- Less than 15 mins
0. As a safety precaution, unplug the range or hit the relevant fuse breaker before you start. You might also want to grab a flashlight. Definitely do not try to do this while the oven is hot.
1. Pinch the wire over the light bulb cap to remove it. This is inside the oven at the back.
2. Pop off the hemispherical glass cap.
... Read more />3. Unscrew the old light bulb, and screw the new light bulb in its place.
4. Put the cap back.
5. Secure the cap by putting the wire back in its slots on the cap.
No tools needed, the cap is just held in place with pressure from the wire.
1. Pinch the wire over the light bulb cap to remove it. This is inside the oven at the back.
2. Pop off the hemispherical glass cap.
... Read more />3. Unscrew the old light bulb, and screw the new light bulb in its place.
4. Put the cap back.
5. Secure the cap by putting the wire back in its slots on the cap.
No tools needed, the cap is just held in place with pressure from the wire.
Read less
Was this helpful?
Thank you for voting!
hinge on oven door was broken, so oven wouldn't shut
2 of 4 people
found this instruction helpful.
-
Cecilia from Cranbury, NJ
- Really Easy
- Less than 15 mins
-
Screw drivers
Lifted door off the front of stove, real easy, but heavy, took out old hinge, and replaced with new hinge, I just looked where everything was before, I replaced with new, replaced door back on, and I was finished.
Was this helpful?
Thank you for voting!
Left hinge roller was broken.
1 person
found this instruction helpful.
-
Richard from Cle Elum, WA
- Really Easy
- Less than 15 mins
-
Screw drivers
I tapped the screwdriver with a hammer lightly on each of three screws to loosen them. I checked to see the position of the spring on the hinge. I then removed the hinge, put on the new hinge and placed the spring in the exact same position. The door works very good. The hinge replacement was a no-brainer.
Was this helpful?
Thank you for voting!
Door Hinge Roller Broken
1 person
found this instruction helpful.
-
Ed from Hull, MA
- Really Easy
- Less than 15 mins
-
Screw drivers
I followed the instructions of a PartSelect.com customer that was posted on the website. The instructions were great and the repair only took 15 mins. Before I found the PartSelect website I called the dealer who we bought the stove from and they wanted $ 250 for the repair. I went on the PartSelect Website and received the parts within 2
... Read more
days.
Total cost $ 59.65 thru PartSelect. Thanks PartSelect--Great service and Great website
Total cost $ 59.65 thru PartSelect. Thanks PartSelect--Great service and Great website
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
the drip bowls were worn out
1 person
found this instruction helpful.
-
linda from STANTON, MI
- Very Easy
- Less than 15 mins
simply replaced them.
Other Parts Used:
Was this helpful?
Thank you for voting!
Drip bowl from a big box store was too big even though both say 8”.
1 person
found this instruction helpful.
-
Kathleen from INCLINE VLG, NV
- Very Easy
- Less than 15 mins
Ordered the part and set it in.
Was this helpful?
Thank you for voting!
support clips fell out
3 of 7 people
found this instruction helpful.
-
tomi from dallas, TX
- Really Easy
- Less than 15 mins
Parts Select is the only parts place I found on the internet that had what I needed on my first purchase, so when I needed these clips I naturally went back to them. Product was easy to find, price was fine, receipt for payment quick and more importantly receipt of item was super quick. Thanks to the efficiency of this place and my old
... Read more
appliances, I will continue to go to them as needed.
Read less
Was this helpful?
Thank you for voting!
wheel cracked
1 person
found this instruction helpful.
-
david from Layton, UT
- Really Easy
- Less than 15 mins
-
Screw drivers
Pulled out bottom drawer and showed my 13 yr
old boy that the spring needed to go back in same hole, then he did the rest. It was so easy, even a 13 yr old can do it.
old boy that the spring needed to go back in same hole, then he did the rest. It was so easy, even a 13 yr old can do it.
Was this helpful?
Thank you for voting!
Broken Right Side Hinge
1 person
found this instruction helpful.
-
Jeffrey from Buena Park, CA
- Really Easy
- Less than 15 mins
-
Screw drivers
Really easy.
1) Pulled up on oven door and removed it.
2) Removed lower drawer to access springs.
3) Pay attention to which hole the springs are attached under the oven.
4) Remove spring with Needle Nose Plier. If you remove by hand, the spring will likely cut your finger....like mine.
5) Unscrew 3 screws of ... Read more old hinge assembly.
6) Reverse process when placing new assembly in place.
1) Pulled up on oven door and removed it.
2) Removed lower drawer to access springs.
3) Pay attention to which hole the springs are attached under the oven.
4) Remove spring with Needle Nose Plier. If you remove by hand, the spring will likely cut your finger....like mine.
5) Unscrew 3 screws of ... Read more old hinge assembly.
6) Reverse process when placing new assembly in place.
Read less
Was this helpful?
Thank you for voting!
hinge roller broke
1 person
found this instruction helpful.
-
Allen from McCalla, AL
- Really Easy
- Less than 15 mins
-
Pliers, Screw drivers
first open oven door a couple inches and slide door up off hinges, then removed storage drawer to gain access to hinge spring, remove hinge spring with pliers noting which hole spring was attached in.then remove three screws from hinge and installed new hinge put three screws in attached spring back and put storage drawer in and oven door
... Read more
back on.
Read less
Was this helpful?
Thank you for voting!
Broken Hinge
1 of 2 people
found this instruction helpful.
-
Martin from Fords, NJ
- Easy
- Less than 15 mins
-
Screw drivers
Easy Repair. Remove the storage draw under the oven. It lifts out. Lift oven door off of hinges. Remove 3 screws & unhook the spring. Reverse the procedure with the new hinge. Good as new.
Was this helpful?
Thank you for voting!
Oven door only opened 1/4 of the way
1 of 2 people
found this instruction helpful.
-
Beth from Emerald Drive, NC
- Really Easy
- Less than 15 mins
-
Screw drivers
After reading the other DIY's directions, we explored how to remove oven door. When the part came in, my sister who was visiting, removed the oven door (30seconds), removed bottom drawer (30 seconds), noted where spring was attached, took off screws and spring, installed new hinge with roller, took a minute to decide if the new hinge cam
... Read more
e through the back or the front (front), she reattached the spring and screws. Put door back on and then struggles to put the drawer back into place. Total time less than 5 mintues, most time spent on returning bottom drawer to its home. Thanks part select for helping me not burn my self every time I try and get food out of the oven!!! I open the oven door all the way and am so delighted!!
Read less
Was this helpful?
Thank you for voting!
Hanging broiler
2 of 5 people
found this instruction helpful.
-
Doris from Aberdeen, NJ
- Really Easy
- Less than 15 mins
-
Pliers
Quick and easy, thanks!
Was this helpful?
Thank you for voting!
Gas electric ignition system stopped working
1 of 2 people
found this instruction helpful.
-
Henry from LAPORTE, PA
- Easy
- 30 - 60 mins
-
Nutdriver, Pliers, Screw drivers
Replaced old ignition module with new module from parts select.
The most important tip was to label each lead before removing from old ignition module.
The most important tip was to label each lead before removing from old ignition module.
Was this helpful?
Thank you for voting!
Change bulb
3 of 8 people
found this instruction helpful.
-
Louis from LEAGUE CITY, TX
- Really Easy
- 30 - 60 mins
-
Nutdriver
Easy
Was this helpful?
Thank you for voting!