8652 Grill - Parts

This special pumper is secured to the grill lid acting as a cushion to prevent metal on metal contact. Over time due to weathering this part may deteriorate and become brittle eventually requiring replacement. It is an original Weber replacement part that is specially manufactured for use with grills. Please note this durable rubber lid bumper is sold individually.

The bottom panel attaches to the rear panel and the side frames. This panel is an OEM from Weber for use in grills. It is available as an individual replacement part. If this item becomes broken it will need to be replaced and may require a wrench set and a screwdriver during the installation.

This genuine OEM repair kit is used with Weber grills. This is a four-part assembly that includes two posts and two retaining clips. The posts are designed to hold the lid to the body of the grill while still allowing it to move freely like a hinge.

This is a genuine Weber part used with the Genesis, Summit, and Spirit grills. Each pack includes two hinge bolts and two nuts; each pack has the hardware for one door. The top pin of the screws fit into pre-drilled holes in the frame of the front doors. They are held onto the doors with the provided bolts.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Weber grills. It is an identical replacement for a missing or damaged side burner ring that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and applicat...Read moreion of this component. Keep in mind this high-quality part is made of durable metal and is sold individually.

This genuine OEM Weber part is sold individually. If the magnets are rusted or damaged they will not keep the doors shut and would need to be replaced. To prevent your frame or magnets from rusting it is recommended to always cover your grill after use and store in in a dry environment.

This is an authentic Weber replacement part, sourced from the original manufacturer for use with outdoor gas grills. The special right-hand side door is used to cover and provide access to the grills cabinet. This door assembly is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine manufacturer sourced replacement kit designed for use with Weber grills. It is designed to secure the table to the frame. Includes two (2) rectangular metal washers and two (2) bolts. To tighten/loosen these bolts you would need a wrench.

This is an authentic OEM sourced item, it is not an aftermarket imitation. This high quality bezel is specially designed for Weber grills. This is the bezel for lid thermometer which is also called a temperature gauge. Please note, one metal item is included per order. No tool would be needed to replace this bezel.