8652 Grill - Overview

When the lower panel of a gas grill rattles or pulls away from the cabinet, worn mounting hardware may be responsible. This hardware pack provides the fasteners and washers needed to hold a compatible bottom panel securely in position. Check for loose screws, damaged threads, missing washers, panel distortion, and rust around the mounting...Read more points before ordering. A badly corroded panel or frame may also require replacement. Use the grills full model and serial details to confirm fit. Shut off and disconnect the fuel source, then wait until every surface is cool. Support the panel during installation and start all screws loosely before tightening them evenly.

This is a genuine manufacturer sourced replacement thermometer designed for use with Weber grills. It can be used to measure temperature inside the grill and the temperature of the food. Mounting tab fits into slot in the bezel to secure the position of the gauge. This part is made out metal and it is sold individually. Please note the, bezel is sold separately. Dial reads 150 - 700 degrees F.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with grills/ It is an identical replacement for the bumper lid which will prevent any direct metal on metal contact, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware...Read more. Keep in mind this high-quality item is made of durable rubber and is sold individually.

An authentic replacement handle that is supplied from original equipment manufacturer for use with Weber grills. It is a high quality item that provide user with a comfortable grip for the lid. Please note one durable stainless steel handle with the hardware to secure it is included per order.

This is a Genuine Manufacturer Sourced replacement part used on a variety of Weber Grills. This is a Metal (Aluminum) assembly used to prevent drippings and food particles from marring your deck or patio.

This is an OEM part sourced directly from the manufacturer. The spring is designed for use in grills from Broil King, Broil-Mate, Huntington, and Sterling. This part is made of metal, and is placed to provide tension to the control cover. You may require a screwdriver when replacing this part. This item is sold individually.

Restore your grill’s performance with this genuine replacement burner tube set, designed specifically for Weber gas grills and sourced directly from the original manufacturer. Made from durable stainless steel, these burners are built to withstand high heat and resist corrosion, ensuring long-lasting use. The set includes three (3) burner...Read more tubes, each featuring an igniter mounting bracket, an air adjustment shutter, and a spider screen to prevent blockages from insects and debris. Installation is quick and straightforward—no special tools required, just a standard screwdriver. To begin, ensure the gas tank is disconnected for safety. Then, remove the screws securing the old burners and detach them from the control valves. Next, position the new burners and secure them using the included hardware. Once everything is in place, reconnect the gas tank and test the burners to confirm proper operation. This replacement set is perfect for grill owners looking to maintain even heat distribution and consistent flame performance with minimal effort.

These are authentic manufacturer-sourced replacement parts that are supplied for use with Weber grills. This is the hardware kit which is used to secure the burner tubes and grease tray rails, please make sure to check appropriate diagrams of your model for correct application. This item includes four high-quality metal screws, keep in mi...Read morend you will need a wrench or a flat-head screwdriver to install or remove the hardware.

This is an authentic Weber replacement part, sourced from the original manufacturer for use with outdoor gas grills. The metal heat shield is used to deflect heat produced within the firebox away from the control panel assembly. This item is available as an individual replacement part, please see illustrated diagram for associative parts.

This is an authentic Weber replacement part, sourced from the original manufacturer for use with outdoor gas grills. This metal panel is used to cover the rear of the stand or frame. The hardware used to mount the rear panel is included, please see model diagram for associative parts.