8563 Snapper - Parts

This Fuel Filter is a white plastic part attached within the fuel delivery system between the fuel tank and carburetor. Installation is rated as "Easy" and requires a set of pliers and a screwdriver. If broken, there may be a leak or blockage and the part should be replaced. The part may also need to be replaced according to manufacturer'...Read mores specifications, and is a manufacturer-approved part. Refer to your make, model and diagrams to ensure this part is correct.

This is an OEM part sourced directly from the manufacturer. The nylock nut is commonly found in snow throwers and lawn tractors from Murray and Snapper. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different nuts used in the machine. Refer to the p...Read morearts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The nylock nut is available as an individual replacement part.

It is a genuine item that is supplied directly from the original manufacturer for use with Murray and Snapper rear engine riding lawn mowers. The clutch is an important mechanism that helps to engage the unit allowing it to drive. It provides an identical replacement for a faulty or a missing or smooth clutch kit that was installed on a n...Read moreew mower. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality kit is sold individually.

This is an authentic replacement part manufactured for use with lawnmowers. Lawnmower blades can wear out and become dull from normal use. Dull blades tend to rig the grass rather than cutting it cleanly. A new sharp blade can provide a better look to the lawn. This blade is sold as an individual replacement part.

This part is an OEM from Snapper and Murray for use in rear engine rider series. The brake lever assembly attaches to the retaining ring, the split spacer, and the washer. A wrench may be needed during the replacement of this item. Over time this part may break and will need to be replaced. This item is made of metal and is available individually.

This is a genuine replacement part sourced directly from the manufacturer. The screw is commonly found in lawn tractors from Murray and Snapper. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to the parts d...Read moreiagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The screw is sold as an individual replacement part.

Ohms 5/16f

Restrictor clear

Tire&rim 7x1.50

This is a manufacturer-supplied part that is made for use with Murray and Snapper lawn and garden equipment. Bushings are commonly utilized to provide a tight fit between connected components. Over time the material can wear out, get damaged or lost eventually requiring a replacement. This high-quality bushing is made of durable nylon mat...Read moreerial and is sold individually. Refer to the parts diagrams for your model to ensure the correct repair procedure. A wrench set might be needed to replace this hardware.

This is an original Snapper replacement part manufactured for use with rear engine riding lawnmowers. The special aluminum spacer is used to secure the gage wheel. The spacer is hollow, and supports the bolt that goes through the wheel to secure it to the deck. The spacer is sold individually.

This item is made of metal and is available as an individual replacement part. The blade handle spring attaches to the idler control rod and the blade on-off handle. When replacing this part a set of pliers might be required during the installation process. Over time this item may break or bend and will need to be replaced. This is a Murr...Read moreay and Snapper replacement part directly sourced from the manufacturer for use in rear engine riders.