8341 - Parts

This part is available as an individual replacement part and is made of plastic. The bushing goes between the worm shaft support bracket and the worm shaft. It will need to be replaced if it breaks. A set of pliers might be necessary during the installation of this item. This is a Snapper replacement part directly sourced from the manufacturer for use in snow throwers.

Sold individually. This almond knob accepts a D-shaped shaft.

This durable nylon starter rope is an authentic OEM supplied replacement part that is specially produced for use with Briggs and Stratton engines that are commonly installed on Toro lawn and garden equipment. When the rope is pulled to start the engine, it is returned back into the starter pulley by means of the starter spring. One starte...Read morer rope is included per order, please note the handle grip and other parts are all sold separately.

This is a Briggs & Stratton and Toro replacement part directly sourced from the manufacturer for use in engines, generators, tillers, blower-vacuums, and lawn mowers. The breather assembly is made of metal and helps to vent the air from the engine. It might require a socket set, a set of pliers, and a screwdriver to replace this part if i...Read moret becomes broken. The part is sold individually but also includes the gasket-breather.

This is an authentic item that is supplied by the original manufacturer for use with Snapper lawn and garden equipment. The spring is utilized to apply tension on the latch. Over time the part can wear out and stretch eventually requiring a replacement. Please note this high-quality metal extension spring is sold individually. You may nee...Read mored pliers to perform this repair. Refer to the appropriate diagrams for your model when replacing this component.

It is an authentic part which is supplied directly from the original equipment manufacturer for use with Snapper lawn mowers. This is the handle that the clutch cable attaches to. It is made of durable metal and is sold individually. Note, the grip for the handle is sold separately. Make sure to check the appropriate diagrams of your mode...Read morel for the correct installation procedure. To perform this repair a screwdriver will be needed.

This is a genuine manufacturer-approved part which is made for use with Murray and Snapper riding lawn mowers and garden tractors. It is one of the special bushings that are utilized on the equipment. This part acts as a lining for components helping to provide a tight fit. Make sure to check the appropriate diagrams of your model for the...Read more correct application of this hardware. It is made of durable material and is sold individually. You may need a screwdriver and pliers to replace it.

This part is an OEM from Briggs and Stratton, Toro for use with lawn and garden equipment engines. The air filter collar gasket seals the gap between the air filter collar and the carburetor. The most common reason for replacing the air cleaner gasket is if it is damaged, clogged, or missing, causing the engine to not start. This part is ...Read moresold individually. The tools that you will need to replace the air cleaner gasket are a 5/16" socket or nut driver and a Phillips head screwdriver.

An authentic item that is supplied directly from the original equipment manufacturer. This replacement side chute is a high-quality item designed for use with Snapper and Simplicity lawn mowers. It is mounted to the side of the mower deck for the cut grass to be expelled out of. This part is made of durable plastic and it is sold individually, please note the hardware to secure it is sold separately.

This is a genuine Snapper replacement part that has been sourced from the original manufacturer to be used with walk-behind lawnmowers. The idler pulley attaches to the idler clutch arm and is used to engage the drive belt. The idler pulley is priced as a single item.

This part is an OEM sourced directly from the manufacturer for use in Briggs & Stratton engines and Toro lawn mowers. The air cleaner screw attaches to the air cleaner. It may require a wrench during installation. Over time this screw may become stripped or broken and will need to be replaced. Keep in mind this part is made of metal and is sold individually.