8285 - Parts

Support guard

This 0.25-inch-diameter washer with internal lock teeth is an authentic manufacturer replacement fastener used in outdoor power equipment. It has a flanged base, which provides even load distribution and protects the mounting surface from damage during installation and removal. The washer also has inward-facing teeth, providing additional...Read more grip to prevent the secured components from falling off the equipment. Over time, the washer will corrode, crack, or wear down its teeth, leading to equipment instability, noise, and vibrations. Inspect all the washers in your equipment and replace those that are no longer functional. Use a wrench or socket to loosen and remove the old washer, and then position the new one on the mounting surface. Tighten the washer until the flange rests flush against the surface. Each washer is sold individually.

This is an OEM part sourced directly from Snapper. The Latch is used to allow height adjustment on the wheels of many models of Snapper Lawn Mowers. This is a fully metal part, and is sold individually. You will need a small monkey wrench or socket wrench to remove the nut and bolt (not included) to replace this part.

The screw attaches the steel blade to the blade hub. It is a genuine OEM sourced part which is specifically designed for use with lawn mowers made by Murray, Briggs & Stratton, Snapper, and Simplicity. This part is available as an individual replacement part and is made of metal. It will require replacing if it strips or breaks and when replacing this part a wrench will be needed.

This is a genuine Snapper replacement part. The grass bag connector is designed by the manufacturer for use in lawnmowers. This part is made of metal and high-quality plastic, and is used to secure the grass bag to the discharge chute. No tools are required when replacing this item. Simply remove the old part and slot the new one into place. This part is sold individually.

Washer .445idx.78od

This is an original Snapper replacement part. The screw is designed by the manufacturer for use in riding mowers, snow throwers, and tillers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to the parts diag...Read moreram to be sure of ordering the correct part. You will require a wrench when replacing this item. This part is sold individually.