80662 ((ELP21703BV)(Series 3)) Snapper Lawn Mower - Parts

Engine Pulley (25MM x 2-1/8 OD Yellow) Used on Kawasaki Engines.

Knob throttle

This 0.25-inch-diameter washer with internal lock teeth is an authentic manufacturer replacement fastener used in outdoor power equipment. It has a flanged base, which provides even load distribution and protects the mounting surface from damage during installation and removal. The washer also has inward-facing teeth, providing additional...Read more grip to prevent the secured components from falling off the equipment. Over time, the washer will corrode, crack, or wear down its teeth, leading to equipment instability, noise, and vibrations. Inspect all the washers in your equipment and replace those that are no longer functional. Use a wrench or socket to loosen and remove the old washer, and then position the new one on the mounting surface. Tighten the washer until the flange rests flush against the surface. Each washer is sold individually.

Throttle control

Bail opc control

This is an authentic Murray replacement part sourced from the original manufacturer for use with walk-behind lawnmowers. Cables can wear out over time or the connections at the ends of the cable can break. Replacing a damaged cable is a relatively common repair that can quickly get the mower back up and running. This control cable is avai...Read morelable as an individual replacement part, please note pliers and a screwdriver may be required to install the cable.

This is a genuine Snapper replacement part. The middle handle is commonly found on lawn mowers. This part is made of metal, and is used to hold and strengthen the upper handle. You may require a wrench when replacing this part. This item is sold individually.