8008 - Parts

Dewalt genuine replacement part, that is sold individually. 2 are needed for the tools listed below. It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can restore a mot...Read moreor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This replacement switch is a genuine OEM part, not an aftermarket equivalent. It is supplied directly from original equipment manufacturer for Murray riding lawn mowers and tractors. This switch is secured under the seat to prevent the engine from running without a driver in a seat. Mechanical switches over time tend to wear out requiring replacement. Please note, this plastic switch is sold individually.

This is a genuine Snapper replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal wheel bearing is used to provide spacing between the center of the wheel and the axle spindle. This part is priced as a single item, please note two bearings may be needed per wheel.

This authentic item is supplied by the original equipment manufacturer for use with Snapper and Simplicity riding lawn mowers and garden tractors. It is one of the covers for the cushion holder springs. The cover is designed to protect it from dust and other debris which can compromise its functionality. Over time it may wear out or crack...Read more eventually requiring a replacement. Refer to the diagrams of your model for the exact location of this component. Replacing it is a simple task that should not require any special tools, simply pull off the old cover and press on the new one. One durable rubber part is included. Note, the spring itself is not included, it is sold separately.

This replacement ball bearing is a commonly used on Snapper riding lawn mowers/tractors. It is supplied by original equipment manufacturer. Please check your models diagrams for correct location and application of this ball bearing. This is a sealed bearing which is sold individually. Ball bearings are designed to minimized friction between two rotating parts.

This is an authentic manufacturer-sourced component from Snapper. The clutch spring is designed to give enough pressure to the clutch, returning it to original position. This item is fitted onto the clutch idler arm and clutch control cable in the drive system. A screwdriver and a pair of pliers are helpful in making the repair. The metal clutch spring is sold individually.

This ball joint is an authentic OEM component designed for use in lawnmowers and lawn tractors. It is found near the transmission assembly and is responsible for securing the drive system transfer link to the transmission assembly. Over time, the ball joint may experience wear and tear due to continuous use, exposure to dirt and debris, o...Read morer lack of lubrication. The drive system transfer link may disconnect from the transmission assembly, resulting in a loss of power transmission. As a result, the lawnmower may not move forward or backward when the engine is running. Remove the nut on the transfer link and the fasteners on the inside of the hex shaft shield. Carefully detach the ball joint. Secure the new ball joint to the transfer link and hex shaft shield to complete the repair.

Retainer, ring, 3/4

This part is available as an individual replacement part and is made of plastic. The bushing goes between the worm shaft support bracket and the worm shaft. It will need to be replaced if it breaks. A set of pliers might be necessary during the installation of this item. This is a Snapper replacement part directly sourced from the manufacturer for use in snow throwers.