8003 - Instructions

I unscrewed the light cover, removed the burned out light bulb and replaced it with one I ordered on Partselect.com. It was very easy.

removed screws from bottom of microwave... lowered bottom plate.. unplugged motor and replaced with new motor/AC synchronous. Reinstalled bottom plate......... DONE!!

Disconnect power. Remove 4 Philips screws from top of valance. remove valance. Remove 1 screw from top of touch pad panel. Remove 1 screw from bottom of touch pad panel. Lift panel slightly and pull out. disconnect wire plugs. Place panel on table . remove 3 screws from PCB. CAREFULLY lift ribbon cable lock and remove ribbon cable. CAREF ... Read more ULLY release PCB latch and lift up and out. Install new PCB in reverse order. CAREFULLY slip ribbon cable in slot and press lock. replace all plugs, screws and panels in reverse order. Reconnect power and test.

Problem was a faulty door latch switch. I easily accessed the switch by removing the control panel, total of 4 screws. After that, just disconnected the three switch door latch assembly and connected the new one. Took about half an hour and was very easy. Unit works perfectly now.

Very easy to replace just one screw on the top of the vent, if changing your grille vent change out the grease filter and charcoal filter at same time clean both area's of grease if your microwave is above your stove.

1. Removed unit from the cabinet. (2 screws). 2. Remove the outer microwave metal shell. (10 screws). 3. Locate and remove part. (3 screws). 4. Install new part and replace all screws. 5. Install unit back into cabinet. So easy. I will share this site with all of my friends.

Everything just went in place just like it should

First, I checked YouTube to see if there was a video showing how to do the repair ... It's as easy as unplugging the power cord, removing 6-8 screws on the bottom panel, unplugging the wire harness from the AC synchronous motor, removing two screws hold the motor in place, putting the new motor in place with the two screws, connect the tw ... Read more o wires to the brass tabs, replacing the bottom panel, reconnecting the power - and you're done. Easy!

remove the screws from the bottom, leave tthe light wires attached. There are two screws holding the motor on, disconnect and mark the old unit where the yellow wire goes. Mount motor with two screws and connect wires. Turn on Miicrowave for 10 sec, to be sure all is correct. Attacch bottom cover and reattach power cord. Before doing anyt ... Read more hing make sure power cord is disconnected and reattached when sealed.