79080339310 Kenmore Microwave - Parts

This fuse, also known as a cartridge fuse, is a genuine OEM replacement part for microwaves. It has a glass cylindrical body with a metal cap on each end. The cap connects the fuse to the circuit. If the current goes above the fuse rating, the element inside the glass will melt and cut off the electrical current to the appliance. This pro...Read moretects the circuit and surrounding components from overheating and becoming damaged. Once the fuse is blown, the appliance will likely not operate at all, however, the fuse is designed to be easily replaceable. It is recommended to use insulated gloves and to avoid touching any exposed wiring connections. To replace the fuse, use a fuse puller to grip the metal caps and lift it out of the holder. Place the new fuse in the holder and ensure it is properly seated. Turn the appliance back on and check that the circuit is functioning.

This light bulb is for microwaves. Light bulb illuminates the surface below the microwave or the interior of the microwave. Because high-voltage capacitors in a microwave can retain a lethal electrical charge even when the microwave is unplugged, a service technician should install this part unless the owner's manual includes instructions for installing the light bulbs.

This microwave glass turntable tray provides a stable, rotating surface for even heating during cooking. Measuring approximately 13.5 inches in diameter, it is made from heat-resistant tempered glass for durability and safety. Designed to fit select microwave models, this tray helps ensure consistent results by allowing food to rotate smo...Read moreothly throughout the cycle. If your current tray is cracked, missing, or no longer turning properly, replacing it can restore optimal performance. Be sure to confirm compatibility with your microwave model before purchasing.

This OEM waveguide cover in your microwave is a heat-resistant component that prevents food, grease, and moisture from entering the waveguide. It is typically located on the side or top wall of the cooking chamber. If the cover is broken, you may notice cracks, charring, or burns, and potentially see arcing or sparks during operation. Not...Read more replacing a damaged cover can lead to short circuits and the risk of electrical components touching your food. To remove the cover, start by disconnecting the microwave from its power source before opening its door. The waveguide cover is slotted or snapped into place, so gently slide or apply pressure to release it from the clips or slots. Please note that the cover is sold individually.

This door switch is designed for use with various makes and models of microwaves and is a genuine OEM part. This individually sold switch connects to the frame of the microwave through the door switch holder, which will need to be removed completely in order to replace this switch. If your microwave will not start, displays error codes, o...Read morer if the door will not shut properly and the inner light stays on, the switch could have broken from use and is in need of replacement. Due to the high voltage used within the components of microwaves, take extra caution when repairing your microwave. To replace the door switch in your microwave, disconnect the microwave from the power, and use a flat-head screwdriver to gain access to the switch through the main control panel.

This coupler is a replacement mechanical component used to connect and transfer motion between internal assemblies. It is commonly replaced when wear causes slipping, noise, or loss of function.

Sold individually. This grease filter is for microwaves. Grease filter traps grease from the exhaust air. Follow the instructions in the owner's manual when installing this part.

This is an OEM turntable guide with rollers, which works with microwaves.

Hardware is not included. Must be ordered separately.

This microwave door switch works with the door latch to control when the appliance can run, a worn switch may cause the microwave to lose power, fail to start, or trip a breaker, it fits select upper and lower switch locations, high voltage may remain inside the microwave after power is removed, use a trained technician for installation, confirm fit with the exact model number.

This motor rotates the glass turntable in the microwave and accepts a D- shaped shaft.