7021R Husqvarna - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Debris shield broke, wore out the belt, self-propel didn't work as a result
Installed the belt on the debris shield. Once the blade was tightened into place, give the belt a tug and it will install itself onto the pulley.
Parts Used:
-
Charlene from PALM COAST, FL
-
Difficulty Level:Very Easy
-
Total Repair Time:15 - 30 mins
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rear drive wheels bald, no traction
9/16s inch socket, something to prop up one side of the mower (I used a plastic plant pot), and about 5 minutes was all that was needed. Undo the nut on the wheel, remove, replace it with the new one (can't mess it up - just goes on one way which is extremely obvious), replace and tighten the nut -- done. Just that simple. With the new kicks it goes up hill like a champ now (instead of spinning, especially with the grass catcher attached).
Parts Used:
-
Mark from COLUMBUS, OH
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!