5350 - Parts

This is an authentic OEM sourced component which is specially made for use with Dynabrade power tools. It is an identical replacement for a missing or a damaged shim that was installed on a new unit. It provides a tight seal between connected components. Please make sure to refer to the appropriate diagrams of your model for the correct l...Read moreocation and application of this part. Keep in mind this high-quality shim is made of durable material and is sold in a pack of three.

This authentic manufacturer-sourced component is specially designed for use with Dynabrade power tools. It is an identical replacement for a missing or a faulty hardware that was installed on a new unit. Please make sure to check the owners manual and the appropriate diagrams of your model for the exact location and application of this pa...Read morert. Keep in mind this high-quality speed regulator assembly is made of durable material and is sold individually.

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sol...Read mored individually. Replacing this item you would need a wrench to replace this item.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is a genuine OEM part. The Dynabrade tip valve is manufactured for use with orbital sanders, finishers and grinders. This metal and plastic valve often sits in the air inlet bushing, and is supported by a spring. The valve is sold individually, please see specific manual for additional repair information. A pair of pliers, wrench and a screwdriver may be necessary for installation.

It is a genuine OEM part that is designed for Dynabrade grinders and sanders. The valve stem is an important component that connects to the speed regulator assembly. It provides an identical replacement for a damaged or a missing part that was installed on a new unit. Check the owner's manual and the diagrams for your model to ensure the ...Read moreproper repair procedure. Keep in mind this high-quality valve stem is made of durable metal and is sold as an individual item. A screwdriver, a wrench set, and pliers might be needed to replace this part.

This genuine OEM sourced part is specially designed for use with Dynabrade grinders. The insert allows a user to secure a bit, note, this collet is for using bits with 1/4" arbors only. Unfortunately, over time it may wear out and it may begin to fail eventually requiring a replacement to ensure a tight grip. Please make sure to refer to ...Read morethe appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality collet insert is made of durable metal and is sold individually.

This is a genuine OEM supplied replacement part which is used with Milwaukee power tools. Ball bearings are used to reduce friction between rotating parts, they experience constant wear from pressure, heat, vibrations and friction eventually requiring replacement to maintain peak performance. It is a high-quality component which is made of durable metal and it is sold individually.