5350 - Overview

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

It is a genuine replacement o-ring which is supplied by the original equipment manufacturer for use with Dynabrade power tools. This item is utilized to provide an air-tight seal between connected parts, please make sure to check appropriate diagram of your model for the correct use and location of this component. Over time o-rings tend t...Read moreo deteriorate and crack eventually requiring replacement to maintain peak performance. It is a high-quality part that is made of durable rubber material and it is sold individually.

This is an original part from the Milwaukee manufacturer. The 1/4" lockwasher is made for use with a variety of power tools and appliances. This item keeps bolts and nuts from coming loose from vibration. A wrench, hex key and a screwdriver are often helpful in making the repair. The 1/4" lockwasher is sold individually.

This is an authentic manufacturer-approved replacement part which is specially designed for use with Milwaukee rotary hammers. The purpose of this o-ring is to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Un...Read morefortunately, over time the material may wear out and begin to fail eventually requiring a replacement. Keep in mind this high-quality rubber seal is sold individually.