My Orders
5001 - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
5 HP Briggs and Stratton chipper shredder - no spark
19 of 26 people
found this instruction helpful.
-
Thomas from ALFRED, ME
- Difficult
- 30 - 60 mins
-
Nutdriver, Pliers
Removed old sparkless magneto, replaced with new part PS9278124 Magneto, and still no spark. The only conclusion that I can draw, is this magneto is defective,
Was this helpful?
Thank you for voting!
Push mower leaked under neath.
1 person
found this instruction helpful.
-
Raymond from Coalport, PA
- Easy
- 15 - 30 mins
-
Pliers, Socket set
Pulled the old seal out, replaced it with seal #391483S and so far looking good !
Was this helpful?
Thank you for voting!
Leaking gaskets
4 of 12 people
found this instruction helpful.
-
Dustin from BANGOR, ME
- A Bit Difficult
- More than 2 hours
-
Socket set, Wrench set
All the gaskets needed to be replaced on the Briggs 6.75 flathead I was rebuilding. I ported and polished the ports and shaved the eyebrow between the valves and the piston. The gasket set was a perfect fit. It is a monster now. It doesn't sound like a lawnmower engine anymore
Was this helpful?
Thank you for voting!
Generator would not start, Birggs & Stratton recommended to replase Gasket Exhaust.
11 of 44 people
found this instruction helpful.
-
Alberto from PALMETTO BAY, FL
- Really Easy
- 30 - 60 mins
-
Socket set
Remove the spark suppresser, 4 face screws, 2 bottom screws and the two screws the hold the gasket. I also had to back out the top screw of the cover it blocked and prevented the removal of the gasket.
Was this helpful?
Thank you for voting!