3801 - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Borken end caps on freezer door retainer
-
Gerald from Brunswick, OH
- Really Easy
- Less than 15 mins
Took the broken ones off, placed the bar on the end caps and snapped them into the freezer door.
Was this helpful?
Thank you for voting!
fan and compressor wont start
-
JOSE from NEW YORK, NY
- Really Easy
- Less than 15 mins
-
Screw drivers
Googled the model number of refrigerator with symptoms of "refrigerator wont run". Parts select web site appeared on my screen, opened Parts Select website, Partselect said probable cause of my frige symptom was that the run capacitor usually burns out 51% of the time. They were correct with the diagnosis 100%. I ordered the run capacito
... Read more
r for $23.00, installed it in 10 minutes, refrigerator runs good as new. Thank you for saving me cost of service call. I probably saved $200 or more. I will use Partselect again with my next problem. THANK YOU,
Read less
Was this helpful?
Thank you for voting!
Broken end cap
-
Roger from Eldridge, IA
- Really Easy
- Less than 15 mins
Just snapped in the replacement. 15 second repair. I was not completely sure that I had the right one ordered. There were two choices. I selected one and it worked fine.
Was this helpful?
Thank you for voting!
compressor running and hot, refer and fridge room temp.
-
Charles from Durham, CA
- Really Easy
- Less than 15 mins
Watched a youtube on capacitors- though on a motor with a pulley, the symptoms were the same, motor running and pulley not turning-bad capacitor. Took a chance for a 17+ dollar part vs a new compressor. It worked.
Was this helpful?
Thank you for voting!
door shelf end cap broke off
-
Leonard from Niagara Falls, NY
- Really Easy
- Less than 15 mins
easily popped the new one in.
Was this helpful?
Thank you for voting!
light would not stay on
-
Kenneth from Leavenworth, KS
- Easy
- Less than 15 mins
First I flipped breaker to off position for refigerator, Pulled down on socket and broke it free. Then took needle nose piars to pull wire and plug out from hole, so I could conect to new light socket then snaped it in place . Hardest part was getting wire and plug out of hole.
Was this helpful?
Thank you for voting!
Reistall shelf
-
Oleg from Lees Summit, MO
- Really Easy
- Less than 15 mins
Replaced cap and reinstalled. But I used iron nail inside cover to hold right side because crack was at right hole and right part would not help.
Was this helpful?
Thank you for voting!
needed new light socket
-
Charles from Williamsburg, VA
- Really Easy
- Less than 15 mins
Pulled out old socket.pushed in new one.
Was this helpful?
Thank you for voting!
Both the fridge aqnd freezer would not get cold.
-
Mary from Farmingdale, NY
- Easy
- Less than 15 mins
-
Screw drivers
Easy. Followed the video instrucations. the part was right there next to the compressor.
Was this helpful?
Thank you for voting!