362V Porter Cable - Parts

The pinion goes next to the bearing and connects to the driven pulley. It is a genuine item that is supplied by the original equipment manufacturer for use with Porter Cable and Black & Decker belt sanders. This part is made of metal and is sold individually. A screwdriver might be required to replace this part if it becomes broken.

This is a genuine manufacturer-approved component which is designed for Porter Cable and Black and Decker belt sanders. It is a high-quality replacement for a missing or a damaged driven pulley that was installed on a new unit. The part is an important component of the drive mechanism that rotates the sanding belt. Refer to the appropriat...Read moree diagram for your model to ensure the correct repair procedure. Note, this high-quality driven pulley is made of a durable metal and is sold individually. A screwdriver will be needed to perform this repair.

It is a genuine replacement part that is supplied by the original manufacturer for use with Porter Cable, Black and Decker and Delta power tools. This special ring is generally utilized to secure a component on a shaft, please make sure to check appropriate diagrams of your model for the correct location and application of this hardware. ...Read moreIt is a high-quality ring which is made of durable metal and is sold individually, it is best to use snap-ring pliers to secure or remove it.

Included in part number 879811

This carbon brush and spring carry electric current to the motor?s spinning armature. The brush wears down during normal use and may cause weak power, sudden stops, or heavy sparking. Before replacing it, inspect the brush holder, wire lead, spring, and armature surface for heat or damage. Confirm the brush size and fit with the full tool...Read more model and type number. Unplug the tool or remove its battery before service. Control the spring as the cap is opened, install the brush in the correct direction, and replace both brushes together if the repair guide calls for it.

Genuine Porter Cable replacement part, this item is sold individually. The 3" Shoe Assembly attaches to the base of the 3 X 24 Belt Sanders listed below, The purpose of this part is to allow the sanding belt run against it, it helps to create a smooth flat sanded surface. It includes the metal platen cork & three mounting screws. Over time the platen and cork will start to wear. It should be replaced ASAP then.

This replacement armature is a genuine OEM sourced component which is specially produced for use with Porter Cable and Black and Decker sanders. Due to constant contact with carbon brushes armature will eventually wear out eventually requiring replacement to maintain peak performance. It is recommended to replace both carbon brushes when ...Read morereplacing an armature. This high-quality part includes an armature with a plastic fan, please note the bearings are sold separately.