362V Porter Cable - Parts

This is an authentic manufacturer sourced replacement seal that is commonly utilized on electric power tools. It has multiple uses depending on the equipment, for correct location and use of this hardware please make sure to check appropriate diagrams of your tool. Over time these seals tend to shrink, become brittle and crack eventually ...Read morerequiring replacement. Please note this durable rubber seal is sold individually.

This is a genuine replacement part sourced directly from the manufacturer. The drive pulley is commonly found in belt sanders from Porter Cable and Black & Decker. This part is made of high-quality plastic, and is used to transfer power from the motor to the sanding belt. You will require a wrench when replacing this item. The drive pulley is sold as an individual replacement part.

The key attaches to the pulley shaft and is made of metal. Keep in mind this high-quality part is sold individually. This is an OEM Porter Cable and Black & Decker part directly sourced from the manufacturer for use in drills, saws, and sanders. If this part becomes broken it will need to be replaced and may require a set of pliers and a wrench during the installation.

It is a genuine item which is made for use with Porter Cable power tool. This part is supplied directly from the original equipment manufacturer. It is a special component which helps to connect two lead wires. The part is utilized to connect the on/off switch to the tool. It is a simple plastic item which is sold individually. Replacing ...Read moreit will only require a screwdriver, take apart the housing, remove the old part and secure the wires using the new connector.

This is an authentic replacement ball bearing that is supplied from original equipment manufacturer. It is commonly used on belt sanders. Its purpose is to secure armature while allowing it to spin freely. This ball bearing is sealed on both sides and it is sold individually.

This is a genuine replacement steel bearing from original manufacturer. It is commonly used in Porter Cable and Black & Decker belt sanders. Bearings are parts which separate metal parts to ease in movement and reduce friction. They also stabilize and prevent incorrect direction/tilt during movement. These high-wear parts are replaced regularly. This part is sold individually. Washers etc. sold separately.

This is an OEM part directly sourced from the manufacturer for use in belt sanders made by Porter Cable, Delta, and Black & Decker. The washer fits next to the cap and the seal. A screwdriver may be needed during the replacement of this part. It will need to be replaced if it becomes broken. This item is made of metal and priced individually.

It is an authentic item which is supplied directly from the original equipment manufacturer for use with electric power tools. This high-quality screw is a standard hardware which has multiple applications depending on the model of your unit, please make sure to refer to the appropriate diagrams for the correct location and application of...Read more this part. Keep in mind this part is made of durable metal and is sold individually.