2263 - Parts

The pinion gear attaches to the height adjuster. It is a genuine item that is supplied by the original equipment manufacturer for use with Briggs & Stratton generators and Murray lawn mowers. This part is made of metal and is sold individually. A wrench and set of pliers may be helpful when replacing this part. It will need to be replaced if it breaks or becomes stripped.

Authentic OEM approved replacement item commonly used on Murray walk behind lawn mowers. The purpose of this special bolt is to secure upper and lower mower handles together. The square area under bolts head allows it to stay secure while the lock nut/knob is being tightened. This metal bolt is sold individually.

This authentic item is supplied directly from the original equipment manufacturer for use with Murray lawn mowers. The baffle attaches to the housing. When replacing this part a wrench might be required during the installation process. It is made out of a durable material and will need to be replaced if it breaks. This item is sold individually.

This is a manufacturer-approved part which is specially designed for Murray and Briggs and Stratton lawn and garden equipment. Bearings are generally utilized to provide a tight fit between connected components while allowing for movement with minimum friction. If the part is worn, damaged or is missing, this will provide an identical rep...Read morelacement for the original hardware that was installed on a new unit. Note, one durable metal bearing is included. Refer to the appropriate diagrams for your model to ensure the proper repair procedure. A wrench set will be needed to replace this component.

Adapter-blade 7/8x2.3

Screw.25-20 s-t

Screw hex 1/4-20x.5

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.