1371PRO ((1696262-01-18-2851-33)(2013)) Murray Snow Blower - Parts

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal washer is used to provide spacing between the steering spindle and the front axle assembly. This item is sold individually, please note two washers may be needed.

Deflector Chute Motor

This is a genuine Craftsman replacement part that is sourced from the original manufacturer to be used with snowthrowers. The metal hex nut is commonly used to fasten the bolt that secures the height skid to the auger housing. This item is available as an individual replacement part, please note four nuts may be required.

This high quality OEM supplied replacement part is used on Murray lawn mowers. It is generally used to secure the mulch cover. This part durable metal windnut is sold individually, please note the bolt and washer to helps securing the cover are all sold separately.

Used to hold a shaft with a mating part, such as a gear, this Woodruff Key is sourced directly from the original manufacturer, is made of metal, is grey, and is sold individually, not as part of a kit or assembly. When this part becomes broken or damaged, it should be replaced. You may notice the mating shaft or gear will no longer rota...Read morete together if the part is malfunctioning. Customers rated this repair as Easy.

A genuine item which is supplied directly from the original equipment manufacturer for use with Murray and Snapper lawn and garden equipment. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check the appropriate diagrams for the correct location and use of this screw. Keep...Read more in mind this high-quality component is made of durable metal and is sold individually.

This is a genuine part which is supplied directly from the original equipment manufacturer and is used with Craftsman lawn tractors. The idler pulley applies tension to the belt which then makes the blade to rotate. This part is made of metal and is sold individually. Before installation, disconnect the spark plug wire and make sure the i...Read moregnition key is removed. You will need a socket wrench and an open ended wrench to complete this repair.

This gear case gasket is a genuine OEM replacement designed to seal the auger drive gear case in outdoor power equipment, helping prevent oil leaks while protecting internal gears from moisture, dirt, and debris. Manufactured from durable material suited for high-load and cold-weather conditions, it maintains proper gearbox sealing and in...Read moreternal pressure for smooth, efficient operation. It is an ideal replacement when a worn or damaged gasket causes oil seepage, contamination, or gearbox performance issues, helping extend the life and reliability of the drive system.

This item is available as an individual replacement part. The collar thrust goes between the hub friction disc and the pin-loop. During replacement, it may require a wrench to help install this part correctly. It is made of plastic and will require replacing if it breaks. This genuine item is supplied by the original equipment manufacturer for use with Murray and Simplicity snowblowers.

The retainer attaches to the idler arm support. This genuine item is supplied by the original equipment manufacturer for use with tractors and rear engine riders made by Snapper, Murray, and Simplicity. It is made out of metal and is sold individually. During the installation process, a wrench set might be needed to replace this part. Over time this part may break and will need to be replaced.

Bolt 3/8-16x.75 g5