1065172 Kenmore Refrigerator - Parts

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Sold Individually. - * Part may differ in appearance, but functions same as original.

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read moreotective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.

This clip is sold individually.

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

This door gasket is used to seal the freezer door when closed.

The water tubing supplies water to refrigerator components that require water including the ice maker and water dispenser. If your refrigerator is leaking water, check the outlet tubing for cracks or holes, as well as the connection points to ensure they are fitted tightly. Faulty tubing should be replaced immediately. Make sure to unplug the refrigerator and shut off the water supply before installing this part.

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

This part consists of a cube and arm that upon activation opens the ice container gate and allows the ice cubes to enter into the chute and into the ice and water dispenser.

This is a plastic tubing insert kit for a refrigerator ice maker. This kit includes a package of four tubing inserts. The kit does not include other parts such as the ice maker water fill tube kit or ice maker fill tube gasket, so consider ordering those parts if necessary. The inserts are used with 1/4-inch plastic tubing. The inserts at...Read moretach on the end of the water tubing to provide a smooth and solid connection between the water tubing and the clamp that attaches the tubing to the water fill valve. This is an OEM part from the genuine manufacturer.