03036 Generator - Parts

This connector is sourced from the original manufacturer as a replacement part for use in generators. The connector has 6 pins/terminals which allow the joining of various electrical cables and components in the generator. Over time the connector can break or wear down, rendering it unable to secure components together. This can result in...Read more electrical hazards, overheating, instability, and loose connections. Disconnect the wires/cables connected to the old connector and remove it from the housing. Place the new connector in the housing and reconnect the wires to the appropriate terminals, following the guidelines in your equipment manual.

This is an authentic Briggs & Stratton replacement part that has been sourced from the original manufacturer to be used with generator engines. The spark arrester screen connects to the muffler and is used to prevent embers from being discharged through the exhaust gasses. Over time the screen can become clogged from exhaust discharge and...Read more can inhibit the gasses from escaping. This item is available as an individual replacement part.

This is an authentic Briggs & Stratton replacement part. The bearing is commonly found in generators. This part is made of metal, and is used to allow the rotor assembly to spin freely within the stator. You may require a wrench when replacing this part. This item is sold individually.

This is an OEM part sourced directly from the manufacturer. The bearing carrier is commonly found in generators from Briggs & Stratton and Snapper. This part is made of metal, and is used to hold one end of the stator assembly and the brush holder. You will require a wrench when replacing this item. This product is sold with a flexible rubber O-ring.

This item has been sourced from the original manufacturer to be used with portable generators from Briggs & Stratton. The metal and rubber mount is used to support the motor. This item absorbs vibration between the motor and the frame. The mount is priced as a single item.

This OEM Axle Shaft is a 5/8" diameter silver metal part, which attaches to the wheel to provide movement. If broken due to damage/fatigue, it will be hard to maneuver around and the part should be replaced. This part is rated "Easy" to install, and requires pliers, a socket set, and a wrench set. Refer to your make, model and diagrams to ensure this is the correct part for you.

This battery charger is used with a variety of portable generators. It is supplied directly from original equipment manufacturer and it is sold individually. It is used to deliver power from an outlet to the unit. Please note that a weak or defective battery can damage the charger. Weak batteries are batteries with bad cells that would no...Read moret hold charge. It is advised to test your batteries if you are unsure if the problem is in the charger or the batteries.