03033 Generator - Parts

This is an authentic Briggs & Stratton replacement part that has been sourced from the original manufacturer to be used with small engines. The muffler connects to the cylinder\'s exhaust port and is used to reduce noise produced by the engine and to prevent sparks from exiting the combustion chamber. This item is available as an individual replacement part.

Screw hex 1/4-20x.5

This is a genuine OEM sourced component that is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is designed to keep the fuel in the tank. It provides an identical replacement for a missing or a faulty part that was installed on a new unit. Please make sure to check the approp...Read moreriate diagrams of your model for the correct location and application of this cap. Keep in mind this high-quality part is made of durable plastic and is sold individually.

This connector is sourced from the original manufacturer as a replacement part for use in generators. The connector has 6 pins/terminals which allow the joining of various electrical cables and components in the generator. Over time the connector can break or wear down, rendering it unable to secure components together. This can result in...Read more electrical hazards, overheating, instability, and loose connections. Disconnect the wires/cables connected to the old connector and remove it from the housing. Place the new connector in the housing and reconnect the wires to the appropriate terminals, following the guidelines in your equipment manual.

This is an authentic Briggs & Stratton replacement part that has been sourced from the original manufacturer to be used with generator engines. The spark arrester screen connects to the muffler and is used to prevent embers from being discharged through the exhaust gasses. Over time the screen can become clogged from exhaust discharge and...Read more can inhibit the gasses from escaping. This item is available as an individual replacement part.

This is an authentic Briggs & Stratton replacement part. The bearing is commonly found in generators. This part is made of metal, and is used to allow the rotor assembly to spin freely within the stator. You may require a wrench when replacing this part. This item is sold individually.

This is an OEM part sourced directly from the manufacturer. The bearing carrier is commonly found in generators from Briggs & Stratton and Snapper. This part is made of metal, and is used to hold one end of the stator assembly and the brush holder. You will require a wrench when replacing this item. This product is sold with a flexible rubber O-ring.