03021 - Parts

This is an authentic Briggs & Stratton replacement part that has been sourced from the original manufacturer to be used with generator engines. The spark arrester screen connects to the muffler and is used to prevent embers from being discharged through the exhaust gasses. Over time the screen can become clogged from exhaust discharge and...Read more can inhibit the gasses from escaping. This item is available as an individual replacement part.

This is an authentic Briggs & Stratton replacement part. The bearing is commonly found in generators. This part is made of metal, and is used to allow the rotor assembly to spin freely within the stator. You may require a wrench when replacing this part. This item is sold individually.

This is an OEM part sourced directly from the manufacturer. The bearing carrier is commonly found in generators from Briggs & Stratton and Snapper. This part is made of metal, and is used to hold one end of the stator assembly and the brush holder. You will require a wrench when replacing this item. This product is sold with a flexible rubber O-ring.

This item has been sourced from the original manufacturer to be used with portable generators from Briggs & Stratton. The metal and rubber mount is used to support the motor. This item absorbs vibration between the motor and the frame. The mount is priced as a single item.

This OEM Axle Shaft is a 5/8" diameter silver metal part, which attaches to the wheel to provide movement. If broken due to damage/fatigue, it will be hard to maneuver around and the part should be replaced. This part is rated "Easy" to install, and requires pliers, a socket set, and a wrench set. Refer to your make, model and diagrams to ensure this is the correct part for you.

This is an OEM part to be used with Briggs & Stratton portable generators. The muffler is used to reduce the overall noise-production of a combustion engine and prevent spark output by providing an end cap on the exhaust. This high-quality metal part is sold individually. You will need a wrench to complete replacement.

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Briggs and Stratton and Toro engines. When pulled, the starter rope engages starter spring causing the engine turn fast enough for the ignition module to generate a spark to ignite the fuel in the cylinder. This part is made of nylon ...Read morerope and is sold individually. To install the rope you will need a screwdriver and socket wrench. Turn the starter spring to build tension and recoil the rope inside.