0200 - Parts

This is an authentic Briggs & Stratton replacement part that has been sourced from the original manufacturer to be used with small engines. The gasket connects to the oil fill spout and is used to seal the spout and to prevent contaminants from entering the engine oil. Tools are not needed to install this item and it is sold as an individual replacement part.

This part is an OEM from Briggs & Stratton. The (metal) air cleaner base is compatible with many small engines. This part helps to protect the air cleaner filter in the engine. A wrench is necessary for the removal and replacement. This item is sold individually. Please be sure to refer to specific manual and diagrams for repair instructions.

Genuine Milwaukee replacement part This brush is sold individually, 2 are needed for the tools shown below It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can restore...Read more a motor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This bearing is an authentic part produced by the original manufacturer. It is compatible with a variety of Milwaukee handheld power tools. Ball bearings reduce friction between metal parts. They allow parts such as axles and shafts to rotate freely and steadily. Ball bearings are high wear components and are commonly replaced. Sold separately.

This cord protector is a genuine Milwaukee replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.