0157 Briggs and Stratton - Parts

The battery charge rectifier goes inside the control box. It is an OEM from Briggs & Stratton for use in generators. This part is sold individually and is made of metal. A wrench and a screwdriver may be required to replace this part. It will need to be replaced if it breaks.

The manufacturer certified M8 Flange Nut is an 8mm silver, serrated, metal part. It can be installed using a wrench or socket, and is used to secure parts in place and secure the load. If broken or damaged, the nut and part may be loose and it should be replaced. Check your make, model and diagram to ensure you are choosing the correct part.

This item is available as an individual replacement part. The outlet is made out of metal and plastic. It may require a wrench during installation. This item will need to be replaced if it breaks. It is a replacement part directly sourced from the manufacturer for use in generators made by Briggs & Stratton and Snapper.

This is an authentic component is sourced directly from the original equipment manufacturer. It is the part that is specially made for use with Briggs and Stratton and Snapper pressure washers. The purpose of this o-ring is to provide a tight seal between connected components. Unfortunately, over time it may wear out and begin to crack ev...Read moreentually requiring a replacement. Please make sure to check the owners manual and the diagrams of your model for the correct installation of this part. This high-quality o-ring is made of durable rubber and is sold individually.

This connector is sourced from the original manufacturer as a replacement part for use in generators. The connector has 6 pins/terminals which allow the joining of various electrical cables and components in the generator. Over time the connector can break or wear down, rendering it unable to secure components together. This can result in...Read more electrical hazards, overheating, instability, and loose connections. Disconnect the wires/cables connected to the old connector and remove it from the housing. Place the new connector in the housing and reconnect the wires to the appropriate terminals, following the guidelines in your equipment manual.

This is an authentic Briggs & Stratton replacement part that has been sourced from the original manufacturer to be used with generator engines. The spark arrester screen connects to the muffler and is used to prevent embers from being discharged through the exhaust gasses. Over time the screen can become clogged from exhaust discharge and...Read more can inhibit the gasses from escaping. This item is available as an individual replacement part.

This is an authentic Briggs & Stratton replacement part. The bearing is commonly found in generators. This part is made of metal, and is used to allow the rotor assembly to spin freely within the stator. You may require a wrench when replacing this part. This item is sold individually.

This is an OEM part to be used with Briggs & Stratton portable generators. The muffler is used to reduce the overall noise-production of a combustion engine and prevent spark output by providing an end cap on the exhaust. This high-quality metal part is sold individually. You will need a wrench to complete replacement.