Maytag Microwave Motors

Maytag Appliance Parts
Shop By Part Type

Popular Maytag Microwave Motors

Your Price
$106.62
  In Stock
Turntable Motor
★★★★★
★★★★★
(14)
PartSelect Number PS2342194
Manufacturer Part Number W10210848
This motor rotates the glass turntable in the microwave.
Fixes these symptoms
Installation Instructions
Michael from YUMA, AZ
Rattling noise when turn table was in motion
Unplug any appliance before any work is done. The microwave is a hanging unit under kitchen cabinets. First I removed the turn table, rollers, and connector by lifting them out. Second I removed all the attaching Phillips head screws that hold the bottom cover on. Once removed the cover will hang and give access to the drive motor gear assembly. It's held in place by 2 torques head screws. Remove these, lower the motor, and disconnect the 2 wires that plug onto it. A small pick or similar tool is needed to release the connectors latches. reassemble in reverse. Read more...
Your Price
$32.68
  On Order
Microwave Turntable Motor
★★★★★
★★★★★
(1)
PartSelect Number PS11755189
Manufacturer Part Number WPW10466420
Fixes these symptoms
Your Price
$72.18
  On Order
Turntable Motor
PartSelect Number PS11769794
Manufacturer Part Number W10911403
Fixes these symptoms
Your Price
$135.80
  On Order
MOTOR-FAN
PartSelect Number PS11703401
Manufacturer Part Number W10794022
Your Price
$78.99
  In Stock
Turntable Motor
★★★★★
★★★★★
(2)
PartSelect Number PS11749221
Manufacturer Part Number WPW10159107
This motor rotates the glass turntable in the microwave.
Fixes these symptoms
Installation Instructions
Glen from Colleyville, TX
turn table motor shaft sheared
Removed microwave from cabinet after removing trim. Placed microwave upside down and removed bottom duct work.(two screws)
Base of microwave had a removable panel that gave access to motor. Removed and replaced motor. (one screw and plug in connector)
Replaced duct work, reinstalled duct work and placed microwave back into cabinet. Replaced trim.(four trim screws)
Note: Whirlpool would NOT sell the turn table support because of "liability".
Read more...
Your Price
$62.44
  On Order
Turntable Motor - 120v
★★★★★
★★★★★
(3)
PartSelect Number PS1961310
Manufacturer Part Number W10143959
This motor rotates the glass turntable in the microwave.
Fixes these symptoms
Installation Instructions
duane from san diego, CA
Fire in microwave melted several parts
Remove the filters and use a Torx driver to remove two screws holding the motor. The wires on on the motor are held in place by a plastic clamp that must be pried open on one side. That's all it takes to replace the drive motor. Everything else that makes the turntable spin lifts off from inside the microwave. Read more...
Your Price
$69.22
  On Order
Turntable Drive Motor
★★★★★
★★★★★
(1)
PartSelect Number PS11742994
Manufacturer Part Number WP58001047
This motor rotates the glass turntable in the microwave.
Fixes these symptoms
Installation Instructions
Tim from Oviedo, FL
Turntable on Maytag MMV5100AAW Stopped Turning
Symptom: Turntable stopped turning. Was able to remove the glass tray in the microwave and the little cam that drives the glass tray was barely turning. Control on microwave to turn the turntable on/off was working as evidenced by the cam not turning when I turned off the turntable. When I turned the cam manually, I could feel the motor turn so I knew the CAM and motor shaft were not stripped.

Repair Procedure:
1) Unplug the microwave.
2) Remove the 4 screws from the bottom of the microwave while holding the bottom cover so that it does not suddenly drop. It is not very heavy so you are fine to hold it with one hand and unscrew the screws with the other. Don't drop it as it has a glass lens for your lights and two light bulbs that light up the cooktop below.
3) Swing the front of the cover down slowly. You wil notice that the back is held in by tabs that slide into the back of the microwave. The bottom cover comes off very easily with some forward motion to dislodge the tabs.
4) Now look up under the bottom of the microwave(assuming your microwave is mounted over the range like mine) and you will see the turntable motor (GEAR MOTOR) in the center.
5) Carfully remove the two wires from the motor by gently working the connectors off of the motor using neegle nose or regular pliers. Don't grab the wires as you may pull them out of the connectors. Work with the connectors on the motor terminals. You will find the job much easier to do if you also remove the wires from the light housing. This will allow you to set the bottom cover aside and will give you greater access to do the job.

NOTE: Now is a great time for you to clean the filters, filter slots, bottom cover, and the light lens. A lot of grease can accumulate on the bottom of the microwave if it is mounted over a range (like mine). If you remove the light assembly, you can clean the cover, filters, and and light lens in the sink. Make sure that you dry all components thoroughly before re-assembling.
6) Make a note of which wires go to which terminals on the motor and the lights.
7) Remove the two screws from the motor and remove it. Note that there is a little plastic insulator film, a very thin washer and a bushing associated with the motor. You will want to re-install these with the new motor. Replace the motor with the new one being careful to put the other pieces back in place as well. Note that the little black turntable cam has a tab on one side so if you want to put it out of the top, you will need to tilt it slightly.
8) With the motor and associated parts back in and secured with the two screws previously removed, re-attach the wires to the lights and motor.
9) Replace the cover and screws and you are done!

This repair is much easier than these steps would suggest but I wanted to be thorough.

I called Maytag and they refused to sell me the part because they said it was dangerous for the user to replace it - rubbish. As long as you kill the power to the microwave and confine your work to the bottom of the unit as described, you will be fine. Maytag wanted to send out a repairman at $80 just to show up. I did the entire repair myself in about 15 minutes for about $40.
Read more...
Your Price
$65.51
  In Stock
Turntable Motor
PartSelect Number PS2052778
Manufacturer Part Number 56001361
This motor rotates the glass turntable in the microwave.
Fixes these symptoms
Installation Instructions
Frederick from Scottsdale, AZ
Microwave turntable would not turn
Turned off circuit breaker to microwave. (Built-In microwave). Unscrewed four screws at bottom panel of microwave to expose electrical wires/plastic plug to existing microwave motor.
Disconnected plastic plug/clips to motor and microwave lights(to allow entire bottom panel to drop down fully from back hinges). Unscrewed mounting screw for motor and removed old motor. Replaced motor and screwed mounting screw back in. Re-attached electrical connections for motor and lights. Closed panel and screwed bottom panel back on. Turned circuit breaker back on. 15-20 minutes start to finish.
Read more...
Your Price
$174.20
  In Stock
Exhaust Fan Motor
PartSelect Number PS11754471
Manufacturer Part Number WPW10416638
This part removes any grease or odors in the air while microwave is in use.
Your Price
$71.60
  On Order
Turntable Drive Motor
PartSelect Number PS2150911
Manufacturer Part Number DE31-10104D
This motor rotates the glass turntable in the microwave.

Related Parts