Hotpoint Microwave Fuses

Videos!

Your Price

$21.31

Hotpoint Microwave Fuse

★★★★★

21 Reviews

PartSelect Number PS1481237

Manufacturer Part Number WB27X10928

This ceramic microwave fuse is just over an inch in length. It is white in the center, and metal on both ends. This is a 20-amp fuse, and is used to power your microwave. If the touch pad on the microwave becomes unresponsive, the microwave produces little to no heat, or the appliance simply does not turn on, it could mean that your fuse is at fault and needs to be replaced. Because this part contains an electrical charge, remember to disconnect power to the microwave unit before you begin this repair. NOTE: Before you start this repair, ensure that the microwave is unplugged, and the capacitor is discharged. A capacitor stores large amounts of electricity even after your microwave is unplugged.

Fixes these symptoms

No heat
Touchpad does not respond
Won’t turn on
See more...

Installation Instructions

Kim from Cliffside Park, NJ

Microwave completely stopped working

Turned out the issue was easily solved by replacing a single, inexpensive fuse.

First off, UNPLUG THE MICROWAVE.

The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove another screw that holds a small metal grill in place. Removing the small metal grill is probably the toughest part of this repair. You kind of have to rock it back and forth a bit to get it to release. Once that's off, you can get to the fuse. I removed the burnt out one with a pair of needle nose pliers. I also put a small piece of cardboard under the fuse when I did this so I didn't accidentally drop it into the innards of the microwave. I did the same thing when I replaced the new fuse. I then plugged the appliance back in and made sure it worked. Once that was confirmed, I replaced both grills. Read more...

Your Price

$54.01

Hotpoint Microwave Fuse

★★★★★

4 Reviews

PartSelect Number PS3486694

Manufacturer Part Number WB27X11138

This fast-blow glass fuse is a genuine replacement component designed to protect microwave ovens from electrical damage caused by power surges or internal malfunctions. Rated at 20 amps and 125 volts, it interrupts the power supply when excessive current is detected, helping to safeguard sensitive internal components. Measuring approximately 6x30mm (0.24 x 1.18 inches), this fuse is compatible with a wide range of microwave models from GE, Hotpoint, and Frigidaire. Replacing a blown fuse is a common repair when a microwave fails to power on or experiences intermittent electrical issues. Always confirm compatibility with your specific model before installation.

Fixes these symptoms

Won’t turn on
See more...

Your Price

$26.73

Hotpoint Microwave Fuse

PartSelect Number PS239596

Manufacturer Part Number WB27X10454

Fixes these symptoms

Won’t turn on
See more...

Your Price

$52.99

Hotpoint Microwave Thermal Fuse

★★★★★

10 Reviews

PartSelect Number PS239811

Manufacturer Part Number WB27X1127

Fixes these symptoms

No heat
Won’t turn on
See more...

Installation Instructions

Thomas from HAMPTON BAYS, NY

Microwave stopped working it lost complete power

Upon taking the faceplate off (unplugged power source first) I found one of the wires going to the THERMO SW-TCO SENSE TEMP was completely burned away. I cut back the wire and spliced a new section with heat shrink connectors and I replaced the THERMO SW-TCO SENSE TEMP. I plugged the power back in and it works great. Read more...

Your Price

$20.95

Hotpoint Microwave Ceramic Fuse - 15 Amp

PartSelect Number PS240270

Manufacturer Part Number WB27X7

Fixes these symptoms

Won’t turn on
See more...

Installation Instructions

Rob from NEWTON, NJ

PS240270 Ceramic Fuse - 15 Amp

PS240270
Ceramic Fuse - 15 Amp
Easy installation , remove microwave cover housing ,locate fuse by door catch & replace..
Received quickly..
Replaced fuse , removed microwave cover housing , located fuse adjacent door catch removed & installed new fuse... Read more...