Freezer Motors
MAKE THIS REPAIR A GUARANTEED WIN
OVER 2 MILLION PARTS TO ENSURE VICTORY
Shop By Brand
View MorePopular Freezer Motors
- Clicking sound
- Freezer section too warm
- Fridge and Freezer are too warm
- Freezer section too warm
- Fridge and Freezer are too warm
- Fridge too warm
(cardbord) the fan will come off and go back on by hand no tools needed i changed the fan motor just to be sure. 3 little screws hold it on. the plug only goes on one way u can't mess it up.very easy job u shouldn't have any problems doing it.Jim
- Freezer section too warm
- Fridge and Freezer are too warm
- Fridge runs too long
Removed the screws holding the back panel.
Removed the fan blade.
removed 3 screws holding the condenser fan.
Remove the 3 metal brackets attached to the fan.
(First note which studs the brackets are attached to. Attach the 3 metal brackets to the new fan. (New screws were supplied)
Cut ... Read more and strip the wire about two inches from the fan.
Cut and strip the new wire. I cut the new wire in half (about 6 inches.) Connect the two wires, twist and used 2 wire nuts. Tie wrap the wire to the wire harness. Mount the new fan (three screws)
Screw the back panel back on.
Mount the new
- Clicking sound
- Freezer section too warm
- Fridge and Freezer are too warm
MAKE THIS REPAIR A GUARANTEED WIN
OVER 2 MILLION PARTS TO ENSURE VICTORY
- Clicking sound
- Freezer section too warm
- Fridge and Freezer are too warm
- Freezer section too warm
- Fridge and Freezer are too warm
- Fridge runs too long
Replacing the screws took a little time the motor mount didn't seem to be tapped exactly for the screws supplied and it was in a tight area. Its working great now.
- Freezer section too warm
- Fridge and Freezer are too warm
- Fridge too warm
- Freezer section too warm
- Fridge and Freezer are too warm
- Fridge runs too long
.The fan is marked as 11.2 DC so I checked for voltage at the fan and found some. With three wires and no wiring diagram I wasn’t sure this answered all the questions, but hooking the fan to a 12 volt power supply didn’t get it to spin.
I priced parts at a couple websites before using partselect.com . They also have a good diagram to look at (Sears diagrams are really poor). I ordered the part with 2-day shipping; it arrived on time, was correct and fixed the problem.