Delta Table Saw Parts

Genuine Delta replacement part, this item is sold individually. The purpose of the is nut is to secure the blade of the Table Saw to the Saw Arbor. It is a left hand ACME thread. It is used on all of the right tilting Table Saws listed below.

Genuine OEM replacement part This brush is sold individually, 2 are needed for the tools shown below It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can restore a motor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This authentic replacement nut is sourced directly from the original equipment manufacturer for use with Delta saws. It is a special hardware which is specially used to secure the saw blade. It is a high-quality component which is made of durable metal and it is sold individually, you will need a wrench to secure or remove it.

This is a manufacturer sourced replacement part designed for use with table saw fences. It helps the fence/rail to slide smoothly. It is made out of plastic and it is sold individually. No tools are required to replace it. You may need pliers to take out the old pad.

This Ball Bearing is sealed on both sides. This genuine Delta replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduces wear on the tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Restore reliable performance to your Delta power tools with this genuine manufacturer-approved replacement switch. Designed for select Delta models, this part controls the on/off function and is a common replacement due to regular wear and tear. Over time, the internal components of switches can wear out, making replacement necessary to keep your tools running safely and efficiently. This switch is sold individually and is built to meet the original equipment standards for quality and durability. Whether you're repairing a favorite tool or performing routine maintenance, this part helps ensure smooth operation and dependable control.

This is a genuine Delta replacement part that has been sourced from the original manufacturer to be used with table saws. The metal riving knife is a safety item that is used to separate material after the cut to prevent kickback. This item is sold as an individual replacement part.

This label provides clear identification and reference markings on a fence component. Proper labeling supports accurate setup and use. Replacing a missing or damaged label restores clarity and safe operation.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Delta and Biesemeyer table saws. This is an identical replacement for a missing or a worn glide pad that attaches to the fence. It helps to reduce friction the fence is adjusted. It is made of high-quality material and is sold as an individual component. Note, the hardware to secure it is sold separately. Make sure to check the owner's manual and the appropriate diagrams for your model for the correct application.