Delta Shaper Parts

It is an authentic item which is supplied by the original equipment manufacturer for use with Delta stock feeder shapers. The roller helps to feed the workpiece through the equipment. It is a high-quality replacement for a damaged or a missing component that was installed on a new unit. Refer to the owners manual and the diagrams of your model for the correct installation of this roller. You will need a screwdriver to remove the guard in order to perform this repair. One durable rubberized roller is included.

The roller attaches to the cover with the washer and the cap screw. This part is an OEM from Delta for use in stock feeder shapers. It is made out of metal and hard rubber and will need to be replaced if it stops turning. An allen wrench will be needed to replace this wheel. Keep in mind that this part is available as an individual replacement even though multiple rollers may be needed.

It is an authentic item that is supplied directly from original equipment manufacturer for use with Delta power equipment. This replacement bearing helps to secure the spindle while allowing it to rotate with minimal friction. For correct location and use of this item make sure to check appropriate diagrams of your equipment. Please note this durable metal bearing is sold individually.

The key attaches to the shaft and is made out of metal. This item is available individually. This is a genuine replacement part sourced from the original manufacturer for use with saws, drills, jointers, and shapers made by Delta. When replacing this part a set of pliers might be required during the installation process. It will require replacing if it becomes bent or broken.

This handle is an OEM direct from Delta. The handle is made for use with a variety of power tools. The metal handle allows the operator to make the needed adjustments for projects. This handle is sold individually. A screwdriver, pliers, socket and wrench set are often required for the proper installation. Please refer to the specific manual for further repair instructions.

This is an authentic replacement part manufactured for use with Delta table saws and routers. The miter gauge is used to change the angle of the cut. This miter gauge is as complete part assembly and is sold as an individual replacement part.

This replacement rubber tire provides the traction a stock feeder needs to grip and move material steadily through the machine. Before installation, unplug the machine and remove the worn tire from the metal wheel hub, taking care not to damage the hub. Clean away any rubber residue, sawdust, and grease, then inspect the hub for damage. If needed, soak the new tire in hot—not boiling—water for three to five minutes to make it easier to stretch. Work the tire gradually over the hub using a smooth plastic tool or blunt screwdriver, then ensure it is seated evenly without twists or raised edges. Reinstall any removed components and guards, rotate the wheel by hand to check for rubbing, and test the feeder with scrap material.

This is an authentic Delta replacement part sourced directly from the manufacturer. The roll pin is found in several different machines from Delta. This part is made of metal, and is put to different uses in the machine, depending on model. Please refer to the parts diagram to be sure of ordering the correct part. This part is sold individually.