DeWALT Utility Vacuum Parts

This 120 volt motor assembly powers compatible dust collectors and utility vacuums. A replacement may be needed if the unit will not start, runs unevenly, loses suction, or has a damaged motor. Unplug the equipment before opening the housing. Check the exact model and type number before ordering.

A vacuum that loses power or works only when moved may have a loose electrical connection. This replacement terminal block holds several internal wires in their correct positions and provides a firm path for electrical current. Inspect it for melted plastic, dark marks, broken mounting points, or terminals that no longer grip securely. Similar symptoms can come from a damaged power cord, weak battery, faulty switch, or worn motor. Disconnect the cord and remove all batteries before service. Handle wires by their connectors, not by pulling on the insulation. Match every connection to the wiring diagram and replace all protective covers before testing the vacuum.

This is an original part that is sourced directly from DeWalt for use with a wet/dry vacuum. This part vacuums up dirt and debris and delivers it to the tank. The hose is made of flexible rubber and includes the attachment ends. This part is sold as an individual replacement part. This part does not require the use of any tools when replacing.

This vacuum hose assembly restores proper suction and airflow on cordless wet/dry vacuums by providing a flexible, durable connection between the unit and cleaning attachments. Built from reinforced rubber with a sturdy connector, it’s well suited for handling both wet and dry debris while resisting wear from regular use. Ideal for replacing a cracked, clogged, or missing hose, this assembly helps maintain effective cleaning performance, especially when reaching tight spaces or cleaning vehicles.

A vacuum that cuts out when moved or requires the battery to be repositioned may have a damaged slide-pack terminal assembly. The terminal block supports the battery and maintains reliable electrical contact during operation. First test with a known-good battery and inspect the contacts for looseness, discoloration, melting, or contamination. Match the replacement to the tools full model and type. Disconnect the battery before service, photograph the wiring arrangement, and protect the terminals from accidental short circuits. After installation, verify that the battery locks securely and that the tool runs without interruption.

This is a genuine DeWALT replacement part sourced directly from the manufacturer. The deflector is found in a wet/dry vacuum from DeWALT. This part is made of high-quality plastic, and is used to direct the flow of air from the flexible hose into the filter assembly and tank. You will require a screwdriver when replacing this part. This item is sold individually.

This is a genuine OEM part. The pcb assembly is made for use with the DeWalt DCV580 Wet/Dry Cordless Vacuum. The control board is secured to the motor in the top of the vacuum base, managing the electrical signals in the vacuum. A screwdriver and pliers are necessary for the installation.

This cold start valve, also referred to as an unloader valve, is supplied by the original manufacturer for use in electric air compressors. It has a length of 0.63 inches, a 1/8-inch male pipe thread, and a hexagonal head for increased stability and security. It allows the compressor to easily start in cold conditions by releasing air pressure from the compressor head or the discharge line which reduces the amount of power needed for the motor to start. Once the compressor starts and the pressure in the tank increases, the valve closes and allows pressure to build. If the valve is faulty, the compressor motor will struggle to start, overheat, or trip the circuit breaker. Disconnect the compressor from the power source and open the drain valve to depressurize the tank. Disconnect the pressure switch line from the valve and unscrew the valve using a wrench. Thread the new valve into place and be careful not to overtighten it. Reattach the pressure switch line and close the drain valve to complete the repair.

This is a genuine DeWalt replacement part that has been sourced from the original manufacturer to be used with wet/dry vacuums. The durable plastic connector is used to attach the hose assembly to the tank. This hose connector may not require tools to install and it is sold as an individual replacement part.