DC500 (Type 1) DeWALT Utility Vacuum - Overview

It is a genuine item that is supplied directly from the original equipment manufacturer for use with DeWALT equipment. The purpose of this switch is to control the on/off function of the tool, unfortunately, over time components will wear out and may begin to fail eventually requiring a replacement. Please make sure to refer to the approp...Read moreriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality plastic body switch is sold individually.

This cold start valve, also referred to as an unloader valve, is supplied by the original manufacturer for use in electric air compressors. It has a length of 0.63 inches, a 1/8-inch male pipe thread, and a hexagonal head for increased stability and security. It allows the compressor to easily start in cold conditions by releasing air pre...Read moressure from the compressor head or the discharge line which reduces the amount of power needed for the motor to start. Once the compressor starts and the pressure in the tank increases, the valve closes and allows pressure to build. If the valve is faulty, the compressor motor will struggle to start, overheat, or trip the circuit breaker. Disconnect the compressor from the power source and open the drain valve to depressurize the tank. Disconnect the pressure switch line from the valve and unscrew the valve using a wrench. Thread the new valve into place and be careful not to overtighten it. Reattach the pressure switch line and close the drain valve to complete the repair.

Battery cap

This 18V battery is a genuine Dewalt replacement accessory, not generic or aftermarket. It is a top of the line XRP (extended run-time) battery with a high amp hour rating allowing it to run up to 40% longer than standard batteries.rn

It is a genuine OEM sourced component that is specially designed for DeWALT vacuums and table saw stands. It provides an identical replacement for a missing or a faulty part that was installed on a new unit, this is one of the feet that support the equipment. Please make sure to check the appropriate diagrams of your model for the correct...Read more location and application of this foot. Keep in mind this high-quality part is made of durable material and is sold individually.