Cub Cadet Log Splitter Parts

This is an authentic replacement part manufactured for use with outdoor power equipment. The carburetor gasket is used to form a seal between the carburetor and the air intake box. It is recommended to replace gaskets when servicing the carburetor to ensure good seals when the parts are reassembled. This gasket is sold as an individual replacement part.

This rubber and plastic spider bushing is a genuine OEM part for various makes of log splitters and is sold as an individual part. Measuring at approximately 2-inches by 2-inches, this bushing is attached to the motor or drive shaft and is used to support the rotating shaft and other components, all while allowing smooth rotation and proper alignment. The spider bushing rides between the couplings, connecting the engine and the hydraulic pump. If you notice excessive vibrations from the motor, check the drive motor shaft for a cracked bushing or couplings, since they work together and are often replaced at the same time.

This genuine flat washer distributes fastener pressure across the mounting surface and may also serve as a spacer in compatible outdoor power equipment assemblies. It measures 0.385 of an inch across the inner opening,0.870 of an inch across the outer edge, and 0.090 of an inch thick. This washer is sold individually, and you should confirm the equipment you are repairing matches with this washer before ordering.

This is a genuine OEM replacement part, it is sold individually. The purpose of this filter is to help eliminate dirt, dust and debris from contaminating the carburetor and damaging the engine. A dirty air filter can cause the engine from operating properly. This filter can be cleaned a time or two by using an air supply. But it is advised to replace it once it becomes dirty.

This coupler connects the engine or motor to the hydraulic pump in your lawn equipment. It has a 0.5-inch inside diameter and is typically located near the rear coupling support bracket. If the coupler is broken, you will notice excessive play, cracks, or a loss of power transmission. Failure to replace a broken coupler can result in reduced power, poor operation, or complete equipment failure. To remove the coupling from your machine, remove any retaining bolts, screws, or clamps securing it in place using a wrench or socket. Afterward, gently wiggle or twist the coupling to release it. This replacement part is sourced directly from its original equipment manufacturer and is sold individually.

This genuine manufacturer-sourced component is specially made for use with MTD and Troy-Bilt log splitters. It is an identical replacement for a missing or a faulty coupling that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually. Note, the other Log Splitter Coupling 718-04392 is sold separately.

This recoil starter is a genuine manufacturer-approved replacement part. It is commonly used in yard machines. When the handle on the rope is pulled, the pulley is rotated. The machine can be started manually through this process. This part is made of plastic, and it should be replaced if it is broken or damaged. A socket wrench is needed to replace this item.

The air valve attaches to the wheel and is made of a durable material. This is a genuine MTD, Ryobi, Yard Machines, Bolens, Troy-Bilt, and Yard Man part sourced directly from the manufacturer for use in chippers, shredders, cultivators, edgers, lawn tractors, snowblowers, and trimmers. Keep in mind that this part is sold individually. When replacing this item a set of pliers might be required during the installation process. It might wear out over time and will need replacing.

This metal hose clip is used to securely fasten small-diameter fuel or fluid lines to fittings such as tanks, valves, or carburetors. It provides a tight, vibration-resistant hold to prevent leaks and line slippage during operation. This is a direct replacement for weakened, corroded, or missing clips to restore safe and reliable hose connections.