Wilton Parts

This deep-groove ball bearing is a durable replacement component designed to support smooth, high-speed rotation in power-driven equipment. Featuring a double metal-shielded design, it helps keep contaminants out while retaining internal lubrication for quieter operation and extended service life. Manufactured from hardened steel and pre-lubricated for immediate use, the bearing is built to handle continuous motion and demanding operating conditions. It is commonly replaced when excessive noise, vibration, or reduced efficiency indicates bearing wear, helping restore reliable, low-friction performance in moving assemblies.

Genuine Manufacturer Sourced replacement part used on a variety of Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is an original part from the Jet manufacturer. The lower (pipe) jaws are constructed of carbon steel, and has been made for use with many vise tools. This item includes two screws, and has curved edges which have been designed to secure pipes and other similar sized materials. This component is sold individually. A screwdriver is necessary in the removal and replacement.

This is a genuine replacement part which is sourced directly from the original manufacturer for use with Jet and Wilton vises. The jaw is an important component which helps to provide a tight grip. It provides an identical replacement for a missing or a damaged part that was installed on a new unit. You may require a screwdriver or wrench when replacing this item. Two durable metal vise jaws and the hardware to secure them are included. Refer to the owner's manual of your model for the correct application. A screwdriver will be needed to perform the repair.

This is an authentic replacement wheel tire for Wilton and Jet band saws. It is supplied directly from original equipment manufacturer and it is sold individually. Its purpose is to provide a stable grip for the saw blade. When attaching the new tire on a band saw wheel, it may appear too be too small, however it really is not. These tires when new are typically approximately two (2) or more inches shorter than the old tire. Tires are supposed to fit very tightly against the bad saw wheel. As the tire ages, the rubber hardens allowing for the blade to slip. Note, it is a good idea to put the new tire in hot/warm water to heat it up just enough to make it pliable enough to stretch. Its advised to have two people in the stretching process.

This screw and handle assembly is an authentic Craftsman replacement part, and is compatible with bench vises. This part lets you loosen or fasten the vise jaws. This assembly includes the screw and the handle that is pre-assembled. This part is made of metal and sold individually.

This is an authentic OEM replacement part used for various handheld power tools including models by Powermatic, Jet, and Wilton. Bearings stabilize and buffer moving parts to facilitate rotation of such parts as shafts, axles, and gears. They are commonly replaced due to this high wear function. This part sold individually.

This item is a genuine part that has been sourced from the original manufacturer to be used with verticle bandsaws from Wilton and Jet. The durable plastic insert fits into the cap in the table where the blade passes through the table. The insert is used to reduce the gap around the blade in order to better support the material as it is being cut. Inserts wear down from normal use, and will eventually need to be replaced to maintain clean accurate cuts. This part is priced as a single item, please note tools may not be necessary to install the insert.

This part is an OEM from the Wilton manufacturer. The carbine blade guard is compatible with many band saw devices. The plastic item is fitted on each side of the saw head's support bracket, keeping the blade straight for cutting projects. A pair of pliers and a screwdriver may be helpful for making the repair. The carbine blade guard is sold individually.