Tanaka Auger Parts

This is a genuine item that is supplied by the original equipment manufacturer for Tanaka lawn and garden equipment. It is an identical replacement for a missing or damaged arm-clutch that was installed in a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and installation of this component. This high-quality part is made of durable metal and is sold individually, keep in mind the hardware to secure it is sold separately.

This is an authentic replacement part which is manufactured for use with Tanaka handheld outdoor power equipment. The clutch along with the clutch drum allow a machine to idle without moving the drive shaft. When the throttle is engaged the clutch expands into the clutch drum which turns the drive shaft. If the clutch spring fails the clutch will not engage the drum and driveshaft, so the engine will run, but the machine will not move. To ensure the correct repair procedure, check the diagrams for your model. Keep in mind this high-quality spring-clutch is made of durable metal and is sold as an individual item.

This fuel line/pipe is a genuine manufacturer approved replacement part. It is commonly used with Tanaka gas powered engines. The fuel line is what delivers the fuel from the fuel tank into the carburetor. Over time it will deteriorate, become brittle and may crack. This item is made out of flexible plastic material and it is sold individually.

This replacement bolt is sourced from original equipment manufacturer for use with Tanaka power equipment. The purpose of this bolt is to secure air cleaner cover to the unit. This bolt consists of a metal shaft and a plastic knob. It is sold individually. No tools needed to install or remove this bolt.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Tanaka handheld lawn and garden equipment. It is an identical replacement for a missing or damaged choke lever that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this component. This part is made of durable plastic and is sold individually, keep in mind the hardware to secure it is sold individually.

The clip goes between the pump filter body assembly and the rubber pipe cap. This is an authentic part from Tanaka for use in bicycle engines, chainsaws, blowers, edgers, trimmers, brush cutters, and power augers. This item is available individually and is made of metal. During the installation process, a wrench and a screwdriver might be needed to replace this part. It will need to be replaced if it bends or breaks.