Rolair Parts

This OEM sourced replacement gauge is designed for use with Rolair compressors. The gauge registers pressure readings and allows you to maintain needed pressure. This gauge is sold individually. You would need a wrench to secure this gauge to the manifold. When replacing this item make sure to unplug the air compressor and bleed out air from the tank.

This drain valve is an OEM direct from Rolair. Compatible with electric and gas compressors, the metal part is fitted at the base of the tank. This item allows the operator to drain the tank following each extended use. Regularly draining the tank prevents rust and leakage. The drain valve is sold individually. A wrench set may be necessary for the proper removal and installation.

This is a genuine OEM approved replacement part designed for use with Rolair compressors. The pressure switch is a mechanism which communicates to your compressor when to stop and when to start building up pressure. There are multiple reasons a pressure switch could be leaking air. To complete this repair you would need: wrench set, nut driver set and a thread-sealing tape. • Shut off the electricity and drain the air tank • Remove the tank pressure gauge • Remove the pressure switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Install the new pressure switch • Reinstall the safety valve • Connect the wires • Reinstall the pressure switch tube • Screw the pressure gauge onto the new pressure switch and tighten the gauge firmly • Test the air compressor

This is a genuine OEM sourced replacement isolator foot that help to keep you air compressor stable and also help to minimize the vibration. This item is made out of rubber with metal and it is sold individually. Please note the screw used to attach it is sold separately. You would need a wrench to replace this item.

Pilot Unloader Valve - 1/4" Tube, Pilot 1/4" M NPT

This is an authentic OEM part. The brass ring is compatible with many Rolair compressor enignes, and is sold individually. This item often helps to connect the tubing between the relief valve and the brass straight. A wrench is needed for making the replacement. Please refer to the manual for additional repair instructions.

This is a genuine OEM sourced replacement part used on Rolair air compressors. Its purpose is to filter out dust and debris from contaminating the engine. This filter is made out of paper, plastic and metal. This item is sold individually. To replace this filter no tools are needed. Simply remove the wing nut that secures the air cleaner cover and replace the filter element.

This regulator is supplied directly from the original equipment manufacturer. Constructed of durable metal and plastic, this item is made for use with several air compressors. The regulator is fastened to the accessory bracket, allowing the operator to select the amount of air pressure for the tool in use. A wrench or pair of pliers may be required for the removal and installation. The regulator is sold individually. Please refer to manual for repair and safety instructions.