My Orders
RCA Range Hardware
GET YOUR OFFICIAL RCA PARTS TO ENSURE VICTORY
Shop By Part Type
View MorePopular RCA Range Hardware
The metallic clip, or also known as a broil element support, is for a oven element on a range. This part holds the broil element in place on top of the oven. If your support clip is broken then this replacement should be the solution. The tools needed for this project are slip joint pliers. For safety precautions, make sure to unplug your range from the power source, or shut off the house circuit breaker before starting this project. Refer to the installation instructions for best results and accuracy.
The metallic clip, or also known as a broil element support, is for a oven element on a range. This part holds the broil element in place on top of the oven. If your support clip is broken then this replacement should be the solution. The tools needed for this project are slip joint pliers. For safety precautions, make sure to unplug your range from the power source, or shut off the house circuit breaker before starting this project. Refer to the installation instructions for best results and accuracy.
Installation Instructions
Paul from Canton, NY
broiling element had burned through, req. its replacement
First I removed the two screws that hold the element in place. I also removed a screw that held one end of a support bracket. I then pulled the element out about 3 inches and disconnected the two wires. Reversing these steps, I finished the element's replacement.
I had noticed that the former element was sagging at the front ... Read more end. I installed the additional clips (not original) on each forward end of the element for additional support.
I had noticed that the former element was sagging at the front ... Read more end. I installed the additional clips (not original) on each forward end of the element for additional support.
Read less
Sold Individually.
Sold Individually.
Sold Individually.
Sold Individually.
Installation Instructions
George from MILWAUKIE, OR
GE WB44T10086 Range Convection Element AP4358533 PS2321875 interrupted
after you disconnect the direct breakers and open the oven:
1. remove the first 4 screws and the fan's cover
2. remove the short screws from element convection assembly
3. gently pool both wires and disconnect the old element (two terminals)
4. carefully insert the terminals in the new element.
5. re-screw the sho ... Read more rt 4 screws (better to buy new ones with the assembly) They are available but sold separated.
6. fix back the fan cover,
re-connect the breakers and that's it!
1. remove the first 4 screws and the fan's cover
2. remove the short screws from element convection assembly
3. gently pool both wires and disconnect the old element (two terminals)
4. carefully insert the terminals in the new element.
5. re-screw the sho ... Read more rt 4 screws (better to buy new ones with the assembly) They are available but sold separated.
6. fix back the fan cover,
re-connect the breakers and that's it!
Read less
MAKE THIS REPAIR A GUARANTEED WIN
OVER 2 MILLION PARTS TO ENSURE VICTORY
