Porter Cable Trimmer Parts

This Ball Bearing is sealed on both sides. It is a genuine DeWalt replacement part and is sold individually. • Ball bearings are used to reduce friction between rotating parts.. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Genuine OEM replacement part Includes 1 Carbon Brush in metal housing for easy installation. • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replaced power tool components. • Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. • Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. • A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. • When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used laminate trimmers. The brushes fit into the motor housing. The brushes are used to relay electricity from the switch to the motor's armature assembly. The brushes are sold as a pair.

This part is available as an individual replacement. The sub-base is made of plastic and attaches to the base. When replacing this part a screwdriver may be needed. It will require replacing if it becomes cracked or broken. This item is an original part from DeWALT for use in laminate trimmers.

This is a genuine OEM replacement part, it is sold individually. This Ball Bearing is sealed on both sides. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. • This reduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is an authentic DeWALT replacement part, sourced directly from the manufacturer. The collet is found in a laminate trimmer, and is used to clamp the bit in place. This is a metal part, and is sold individually. To replace this part, you will need a wrench to loosen the collet nut, and then the collet should be simply to remove. You may also need a screwdriver to reach the part for replacement.

This steel collet nut threads onto a router or laminate trimmer spindle. As it tightens, it presses the matching collet around the bit shank to hold the bit in place. The nut may be sold without the collet cone, so check the package contents before ordering. Match both parts to the complete tool model and required bit size. Unplug the tool, clean the spindle threads, and inspect them for damage. Start the nut by hand and use the correct wrench for final tightening. The bit must remain straight and firmly held before the tool is started.