Porter Cable Generator Parts

This is an OEM part sourced directly from the manufacturer, sold individually. The grommet is inserted into the fuel tank of the generator to hold the fuel drain cock, which can be shut off to stop the flow of fuel, or opened to allow the fuel to flow to run the generator. No tools are required for installation. Part is compatible with the models listed below.

This replacement part is specially designed for Porter Cable, DeWALT and DeVilbiss portable generators. The capacitor is a two-terminal electrical device used to store electrical energy in the form of an electric field. It provides leading current in AC circuits. In a DC circuit, the capacitor once charged with the applied voltage acts as an open switch. This is an identical replacement for a missing or a faulty component that was installed on a new unit. Please make sure to refer to the appropriate diagram of your model for the exact location and the correct repair procedure. Keep in mind this high-quality capacitor is sold individually.

This is a manufacturer approved isolator that is specially designed for use with electric generators. Its mounted between the motor and the frame to help minimize the vibrations caused by a running engine. One durable rubber isolator with a metal threaded shaft is included per order.

This high quality replacement cap is an authentic OEM sourced item that is designed for use with generators. It is designed to keep the fuel in the tank. This fuel cap is made from durable plastic and it is sold individually.

This is an authentic replacement part manufactured for use with air compressors, pressure washers, and generators. The plug tube is used to seal the end of tubing generally used as the machines frame. This tube plug is available as an individual replacement part, please see model diagram for associative parts.

This item is an original part from DeWALT, Porter Cable, DeVilbiss, Delta, and Bostitch for use in compressors. The button snap goes between the plug tube and the handle insert. You may need a set of pliers when replacing this item. Over time this part may break and will need to be replaced. It is made out of metal and is sold individually.

This is an authentic Porter Cable replacement part that has been sourced from the original manufacturer to be used with air compressors from Porter Cable, DeVilbiss, and Black & Decker. The special clamp is used to secure the connections between fuel lines. This item is sold as an individual replacement part.

This genuine OEM fuel tank, also known as the gas tank, in your generator serves as the primary storage for the fuel that powers the engine to produce electricity. Typically positioned on the top of the frame assembly, this gas tank measures 22 inches in length and 18.5 inches in width, with mounting holes positioned 16 inches apart at the center and 3 inches apart from each end of the tank. To determine if the fuel tank needs replacement, inspect it for damage, corrosion, rust, or any signs of leaks. To replace the tank, start by removing the securing screws and disconnecting the gas line. Drain the remaining gas into a container. Remove the gas valve from the old tank and take out the tank. Install the new gas valve onto the new tank and securely place the new tank. After reconnecting the gas line and filling the tank with gas, conduct a thorough check to ensure there are no signs of leaks.

It is an authentic OEM sourced replacement gasket which is specially designed for use with DeWALT generators. This is one of the gaskets that provides an air-tight seal for the carburetor, over time it may wear out and begin to crack eventually requiring a replacement. It is a high-quality component which is made of durable composite material and is sold individually.