Porter Cable Angle Grinder Parts

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

Genuine OEM sourced replacement part used on a variety of power tools. Ball bearings are used to reduce friction between rotating parts. Bearings experience constant wear when the tool is in operation, because of this they need to be periodically checked and replaced if needed. This part is made out of metal and it is sold individually. Included in part number 381004-00 spindle assembly.

This is an authentic manufacturer sourced replacement part designed for use with Dewalt grinders. It helps to provide an air tight seal for the gearbox. It is made out of rubber material and it is sold individually. To complete this repair you will need a spanner wrench.

This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 18 Gauge • 10 Feet Long

It is a genuine OEM sourced item which is specially designed for use with Black and Decker, Porter Cable and Dewalt grinders. This part helps to secure the grinding disk to the shaft, please make sure to refer to the owners manual for the correct application of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually. Please note the outer flange and the wrench are both sold separately.

Genuine Manufacturer Sourced replacement part designed for use with some Angle Grinders. This part is made out of Carbon with a Lead Wire attached. This item includes One (1) Carbon Brush per order. Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

This item is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used with angle grinders and masonry saws. In grinders, the metal spring is used to provide compression for the spindle lock pin. In masonry saws, the spring provides a similar function for the depth adjustment lever lock pin. This item is sold as an individual replacement part.

This authentic manufacturer-supplied washer is specially designed for use with DeWALT angle grinders. It is a special hardware that helps to provide a tight seal between connected components. This is an identical replacement for a missing or a damaged O-ring that was installed on a new unit. One durable rubber part is included. Refer to the appropriate diagrams for your model to ensure the proper replacement procedure. A screwdriver will be needed to take apart and reassemble the housing to perform this repair.

This replacement wrench is a genuine OEM approved part that is used with Dewalt, Black and Decker and Porter Cable agnle grinders. It is used to tighten or remove the outer flange which secures the grinding wheel. Please note this durable metal wrench is sold individually.

This is an original replacement part manufactured for use with angle grinders. The special metal flange sits above the grinding wheel, and provides space between the wheel and guard. This inner flange is sold individually.