All Installation Instructions for General Electric Refrigerator ZFSB26DRCSS

Ice Maker stopped making ice.

Ice maker was side mount instead of rear mount as shown in previous insructions. Removed one screw and slide ice maker forward. used flat head screw driver to undo the ice maker plug. The ice maker came right out. Removed old ice maker fill cup and put it on the new ice maker. Slide the new ice maker into place and used the same screw to secure it. Pluged it in and turned on the ice maker. Had new ice in a couple of hours. It comes with a round plug to square plug adapter, new fill cup and fill tube, all of which I didn't use.

Parts Used:

Ice Maker

Charles from Edmond, OK
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers, Socket set

Was this instruction helpful to you?

Thank you for voting!

Was not making ice cubes

Only needed to remove one screw, slide unit out and disconnect the power cord. Theb reverse the above operation to install the replace ice maker unit. Quick and extremely easy....

Parts Used:

Ice Maker

Bob from JASPER, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

broken light switch

Used a small screw driver to remove the damaged switch. Carefully unhooked the two wires and hooked the wires to the new switch. Pushed the new switch into place. Be careful that the wires do not pull back into the refrigerator wall. Took about 15 minutes. Works like New. Easy fix.

Parts Used:

Light Switch

Kenneth from Charlotte, NC
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Refrigerator Fresh Food condenser iced-up. Frozen side OK

Had to remove all the covers and fans to expose the condenser, which was difficult as the parts were frozen to it. The styrofoam covering the condenser made it almost impossible to defrost it. Therefore, I ripped the styrofoam off to expose the condenser. Was not really difficult to fix the styrofoam cover using metal tape. Replaced temperature sensor in aluminum block, and used butyl sealant to secure. Had to also re-install parts of ice-ball kit that were not well covered. Lots of parts to keep track of, but anyone could do it.

Parts Used:

Temperature Sensor

Dan from Decatur, GA
Difficulty Level:
Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

ice maker very slow and arm that controls amount of ice sticking and quit making ice

took 1 screw out and removed ice maker and slid new one in and replace screw and connected power cord

Parts Used:

Ice Maker

Grimes from Bartlett, TN
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

Was this instruction helpful to you?

Thank you for voting!

Auto dipense of water and ice inop

First determined my modle did not require any of the wire mods descibed on the instructions. Removed power and three cover plate screws. Removed board connectors. Calapsed board anchors and removed board. Removed existing ground wire from board. Installed ground wire on new board and installed board on four mounts. installed connectors and replaced cover and screws. I did wear playtex gloves so as not to cause a static short and wipe out the new board. Took off the bottom panel and cleaned condensor fan cage while I had the fridge out. Secured, plugged in fridge, works real fine, lasts a long time.

Parts Used: