YT12413 Snapper Lawn Tractor - Parts

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal washer is used to provide spacing between the steering spindle and the front axle assembly. This item is sold individually, please note two washers may be needed.

This is a genuine manufacturer-sourced replacement washer which is specially designed for use with Snapper lawn and garden equipment. It helps to distribute the pressure evenly and provide a tight seal between connected pieces, please make sure to check appropriate diagram of your model for correct location and use of this hardware. Keep in mind this part is made of high-quality metal and is sold individually.

This is an authentic replacement part manufactured for use with Snapper lawnmowers. The special nut is commonly used to fasten the bolt that goes through the rear wheel hub. This nut is available as an individual replacement part, please see the model diagram for associative parts.

Roll pin 1/4x1-1/4

This is a genuine part which is supplied directly from the original equipment manufacturer and is used with Craftsman lawn tractors. The solenoid support engages and routes the battery electrical supply to the engine starter when the ignition switch is turned to the start position. This part is made of hard plastic and metal, it is also s...Read moreold individually. The tools you will need for this repair are a screwdriver and socket wrench.

This authentic OEM sourced replacement part is specially designed for use with Murray, Snapper lawn and garden equipment. Ball bearings are generally utilized to reduce the friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces frictio...Read moren. Unfortunately, over time components will wear out and may begin to fail eventually requiring a replacement to maintain peak performance. Keep in mind this high-quality item is made of durable metal and is sold individually.

This flange nut is designed for use in lawn and garden equipment. It is an OEM replacement part with a diameter of 0.375 inches and a thread pitch of 16 threads per inch. The nut has a ring-shaped extension on one end, known as a flange which helps to evenly distribute the clamping force of the nut and provide a more secure hold. Addition...Read moreally, the flange eliminates the need for separate washers and reduces the risk of abrasion on the surface being fastened. It is normal for the nut to corrode, crack, or for the threads to wear down over time. To replace the flange nut, unthread it from the fastener, and insert and secure the new one using a socket/wrench. Each sold individually.

The pushnut retainer goes next to the ball bearing. This is available as an individual replacement part. This item is an OEM from Snapper, Murray, and Simplicity for use in lawn mowers, lawn tractors, and snowblowers. It might require a wrench to replace this part. It is made of metal and will need to be replaced if it breaks.

This is an authentic replacement part manufactured for use with rear engine mowers and lawn tractors from Craftsman. The user will need to replace this hex nut if it is missing or not working correctly. This hex nut screws onto the transmission link lever. This part is made of durable material and sold individually.

This is a genuine Snapper and Simplicity replacement part for use in lawn mowers, lawn tractors, and snowblowers. The key attaches to the disc and is made of metal. A set of pliers may be needed during the replacement of this part. It will need to be replaced if it breaks. This item is sold individually.

It is a genuine OEM sourced component which is specially designed for use with Murray and Snapper lawn and garden equipment. The purpose of this part is to provide a tight seal between connected parts, unfortunately, over time the material may wear out and begin to crack eventually requiring a replacement. Keep in mind this high-quality h...Read moreardware is made of durable nylon and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this thrust washer.