My Orders
X18004G0 Roper Air Conditioner - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Filter was filthy, no telling how long it had been since changed
10 of 14 people
found this instruction helpful.
-
SHIRLEY G. from Mabank, TX
- Really Easy
- Less than 15 mins
Took out old filter and replaced it with the new filter
Was this helpful?
Thank you for voting!
Ac Would Cool But Compresser Would Not Cycle On &Off
10 of 17 people
found this instruction helpful.
-
Ron from Knob Noster, MO
- Really Easy
- 15 - 30 mins
-
Screw drivers
Replaced the temp control and sensor. Controls on this unit are easy to get to and electrical connections were slide ons
Was this helpful?
Thank you for voting!
old filter had become brittle & needed replacing
5 of 11 people
found this instruction helpful.
-
Rhea from Plainview, TX
- Really Easy
- Less than 15 mins
Just removed the old filter and replaced. Slid right in, no tools required.
Was this helpful?
Thank you for voting!
Needed new Ice Maker
5 of 11 people
found this instruction helpful.
-
Joseph from Liberty, MS
- Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers, Wrench (Adjustable)
Removed back cover, and installed the water valve. Removed the water supply tube cover and installed the supply tube. Opened freezer and removed the electrical cover, removed the knockouts and pulled line out. Hooked up ice maker and installed it to wall. Turned water on and waited a couple hours, it is making ice. Installing the ice
... Read more
maker was easy. Running water line to it........well that is another story. LOL.
Read less
Was this helpful?
Thank you for voting!
A/C coils would freeze up and unit would not shut off with temperature control.
1 of 2 people
found this instruction helpful.
-
Travis from Locust Grove, GA
- Really Easy
- 30 - 60 mins
-
Nutdriver, Pliers, Screw drivers
Unplugged unit.
Pulled front cover and removed switch knobs.
Pulled switch plate off and replaced thermostat switch and temperature sensor bulb assembly.
Reassembled and plugged in.
Unit works normal.
Pulled front cover and removed switch knobs.
Pulled switch plate off and replaced thermostat switch and temperature sensor bulb assembly.
Reassembled and plugged in.
Unit works normal.
Was this helpful?
Thank you for voting!
Both motor clips broken - >40 year old dryer!!
1 of 4 people
found this instruction helpful.
-
susan from Socorro, NM
- A Bit Difficult
- 30 - 60 mins
Removed the back - Saw the broken clips on the base of the dryer (the wires to the motor were pulling out because the motor was slipping).
Guessed that the parts were motor clips (no pix in the web site!)
Got the parts in post - they were identical except needed some rubber grips inside to hold tight (Used pieces of ... Read more bike tire inner tube cut to fit for this.) Attached clips. Works fine!!
(Son is an engineer - he found the problem. Husband is a retired doctor - he couldn't!! but together they
supplied the muscle)
Sue (67 years old)
Guessed that the parts were motor clips (no pix in the web site!)
Got the parts in post - they were identical except needed some rubber grips inside to hold tight (Used pieces of ... Read more bike tire inner tube cut to fit for this.) Attached clips. Works fine!!
(Son is an engineer - he found the problem. Husband is a retired doctor - he couldn't!! but together they
supplied the muscle)
Sue (67 years old)
Read less
Was this helpful?
Thank you for voting!