WWTR1611SW1 Westinghouse Refrigerator - Instructions

2 screws out ,bracket out,bracket in,2 screws in DONE

Glued and taped old door rack until new part arrived. Perfect fit.

snapped old one out by hand and installed new one with ease been broken for year could not believe how easy it was

Take down the light assembley by removing the 4 one qurter inch screws, and install the diffuser where it belongs.

Snapped new door rack into place.

I took the cracked pan out, waited for the new pan to arrive (2 days) and slid the new pan right in. It was so easy.

No tools were required to install

Snapped right in place, no problems at all.

I just put them right on. Took about a minute to figure on the right way to put the racks on (push them down from the top, until they snap into place), and it was done in less than five minutes. I was worried that this wouldn't work - I couldn't find the exact item # to replace the racks that had been on there. But it turns out that they ... Read more are pretty interchangeable - the sub racks that the website suggested worked perfectly for me.

It was a perfect fit and snapped into place in seconds. No instructions were required.

snapped the wires from frig onto the proper prong and viola,it works. The proper prong is identified by the size because there are two prongs with the wires and two connecting prongs in the socket. I talked to a very helpful representative and she gave me the number for Frigidaire, when I was confused by the placement of the wire. Wish I ... Read more had remembered her name to share with you. As it turned out I didn't need to call Frigidaire.

Used wood blocks to raise the door off the lower hinge bracket then unscrewed the suspect hinge. Cut a small shim, two layers of soda can, to place under the lower edge of the new hinge bracket and doubled the washers by using the old one to ensure I had adequate clearance for the door. After a little silicone lube I installed the new hin ... Read more ge bracket. All better now.

Removed 2 hex screws & old hinge, placed new hinge on cabinet & found that it didn't fit; one hole was about 1/8" off. Had to drill a new hole in cabinet top in order to attach new hinge. Hinge works fine now. I'm glad to find the hinge is metal; original one was plastic.

Replaced thermo-fuse

The new part fit perfectly! I just snapped it on! Thanks so much Partselect! You processed my order quickly, and I had it in my hands in a few days. What a relief to have this fixed! Thanks again.