EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

WRT17CGAD0 Frigidaire Refrigerator - Instructions

All Instructions for the WRT17CGAD0
106 - 120 of 207

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Freezer & fridge warm / condenser coils iced over
  • Daniel from North Plains, OR
  • Easy
  • Less than 15 mins
  • Screw drivers
Problem not consistent. OK for 2-3 weeks, then freeze coils. Mark and observe the defrost timers manual rotating adjuster. Timer would stop mid cycle. One revolution equals 8 hours of compressor run time followed by 30 minutes of defrost. Replacing timer took 5 minutes.
Was this helpful?
Thank you for voting!
compressor not running
  • wilson from indialantic, FL
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Wrench (Adjustable)
thanks to all of the people who had the same problems I was able to make a quick fix on my fridge. I pulled the back cover off and found the compressor not kicking on so I replaced the start cap. and im back in bussiness.
Was this helpful?
Thank you for voting!
freezer frosted up and air could not circulate to the food section, causing the temperature to get warm, 55 degrees
  • PAUL from WEIRTON, WV
  • Really Easy
  • Less than 15 mins
  • Nutdriver
I followed the procedure online and found the thermostat was ok, it had continuity when cold, and the heater coil was also ok, it too had continuity, therefore the problem was a bad defrost timer. the refrigerator works great, thanks parts select!
Was this helpful?
Thank you for voting!
Freezer was cold bit the refrigerator was warm.
  • Christopher from Wilmington, DE
  • Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Based on the diagnosis on this site I thought the 66% odds of the problem being the Defrost Timer looked pretty good, $30 including shipping versus a Sears tech phone estimate of $250-300. BINGO! Just follow the online installation instructions and don't forget to use the reset switch as described. Works like new! THANK YOU
Was this helpful?
Thank you for voting!
Freezer worked, Frig would not cool.
  • Dean from Sunset, SC
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Unplugged the frig. Removed temp control module from frig, 1 screw with nut driver. Activated defrost timer by rotating adjustment until 2 clicks are heard. Removed two timer mounting screws, unpluged timer, plugged in the new timer, mounted it to the control module with 2 mounting screws. Replaced control module with the 1 mounting sc rew. Closed door and plugged it up.
Was this helpful?
Thank you for voting!
Not defrosting and then warm up do to ice
  • Bryan from Red Oak, IA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
replaced the defrosting timer and saved a lot of $ by doing it my self.
Was this helpful?
Thank you for voting!
Freezer and main compartment had wide temperature variations
  • Joseph from Tullahoma, TN
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I first thought the defroster heater broke - took the back wall of the freezer off and cooling fins were fine. Then took the defroster timer out and opened it up. The contacts were badly burnt so the compressor and fan ran during only part of the cooling cycle. Replacing the timer took less than 5 minutes - turn off the power, remove o ne screw to take out the control box, cut the ground wire (new timer housing is plastic and does not have a ground connection), remove two screws to unmount the timer, unplug the old timer, plug in the new timer, fasten with two screws, put the control unit in and fasten with one screw, turn power back on.
Was this helpful?
Thank you for voting!
Refrigerator Ran Constantly, Was not Cooling as well.
  • Mark from Hertford, NC
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Looked up troubleshooting info on your web site. Decided to replace the defrost timer. Ordered it using Paypal. Received the Shipment in about 1.5 days in Rural NC. Watched Your Video, cut off power to the fridge, removed the top self and unbolted the panel, removed the defective defrost timer, installed the new one and re-installed the panel and top shelf. Set the timer to defrost to check the operation (looked inside the freezer to see that the defroster was glowing red - it was) waited about twenty minutes to ensure that the fridge started cooling again. Fixed!
Was this helpful?
Thank you for voting!
at first auto defrost would not work so I had to take the frezer panel apart and defrost it with a hair dryer every ten days
  • thomas from Chepachet, RI
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
pulled down the thermostat cover and unpluged the timer control and replaced it with the new part. total time to repair was about 15 min. there was a vidio on how to replace the new part that just informed me that I did it right!!!!very easy site to find what you are looking for!!!!
Was this helpful?
Thank you for voting!
fridge shut down stopped running
  • robert from Holbrook, NY
  • Really Easy
  • Less than 15 mins
  • Screw drivers, Socket set
simply watched videos provided…making it EXTREMELY simple..saved me hundreds by not having to throw it out!! running better than ever like as if it was brand new!!
Was this helpful?
Thank you for voting!
Refridgerator not geting cold.
  • VINCENT from DEPTFORD, NJ
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Just followed the online instruction video .It was very easy.
Was this helpful?
Thank you for voting!
freezer cold--frig was warm
  • Robert from Chicago, IL
  • Really Easy
  • Less than 15 mins
  • Screw drivers
You guys at Partselect are the best!!! Went to your site, typed in my appliance symptoms, and received possible fixes. Ordered the suggested parts (under $50) on a Sunday night and got em Tuesday am. Installed the easiest one first and Voila!!!! Frig is working great. Thanks Bob S
Was this helpful?
Thank you for voting!
Refrigerator was not cooling
  • Scott from Norman, OK
  • Really Easy
  • Less than 15 mins
  • Nutdriver
Remove 4 screws that hold up overhead controls, this is also the part that holds the light. Unplug the timer and replace. Super simple and runs great now. After you plug it in it may take a few minutes to kick on the compressor but it will. Also I was pleased it was a factory Frigidare part. Price was right.
Was this helpful?
Thank you for voting!
Refrig would not defrost
  • Robert from Jacksonville, FL
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Diagnosis: used wiring diagram attached to frig and determined cause could be wiring, heater element, thermostat or timer. After completely defrosting the frig (turned it off) I removed the rear cover in the freezer and looked for an obvious problem. None seen. Removed temperature select pod from the frig box and looked for obvious pro blems. None seen but defrost timer appeared poorly made. Repair: Since I had no practical way of checking the defrost cycle in operation, I checked probable failures on the Part Select website and saw defrost timer as most probable. I ordered the timer. Installed it. Waited a few days to make sure the frig went through a few defrost cycles then removed the freezer rear cover. There was no excessive frost buildup so I'm reasonably sure the repair was successful.
Was this helpful?
Thank you for voting!
freezer was freezing and no refrigerator
  • Michael E from Uniontown, PA
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Followed instruction vedeo from partselect. THANKS!!!!!
Was this helpful?
Thank you for voting!
All Instructions for the WRT17CGAD0
106 - 120 of 207