Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Refrigerator keeps frosting up and not cooling
1 of 2 peoplefound this instruction helpful.
Marvin from Pima, AZ
Really Easy
15 - 30 mins
Nutdriver
Refrigerator started frosting up and running all the time.I'd defrost it and it would frost up again in about a week.The timer seems to be work so I just guest it mite be the Defrost Thermostat.I removed the duck in the center and back panel in the freezer compartment defrosted it and switched Thermostats and replaced panel and duck, goi
... Read moreng to lower compartment of the refrigerator.So far it seems to be working a little more time while tell.
Read less
Was this helpful?
Thank you for voting!
No freezing or cold in either freezer or refridgerator - compressor did not run.
1 of 2 peoplefound this instruction helpful.
George from Sunnyvale, CA
Really Easy
15 - 30 mins
Nutdriver, Screw drivers
Traced issue to defrost timer ( burned compressor & element contacts). This unit is mounted next to the temperature adjustment control in the refridgerator area - right in front. Removal of plastic cover provided easy access to the timer. Unit unscrews from the mounting then unplugs. Installation is reverse of removal.
Was this helpful?
Thank you for voting!
broken edges pan-crisper
1 of 2 peoplefound this instruction helpful.
Lauralee from Cottage Grove, OR
Easy
Less than 15 mins
took out old one slid in new one.
Was this helpful?
Thank you for voting!
Defroster didn't work
1 of 2 peoplefound this instruction helpful.
George from Eatonville, WA
Really Easy
Less than 15 mins
Screw drivers
Ordered a new defroster timer and replace old one. It works just fine. A $35 repair vs a $500 new appliance. Cool. GWE
Was this helpful?
Thank you for voting!
door shelf end caps were broken
1 of 3 peoplefound this instruction helpful.
Lupe from Las Cruces, NM
Really Easy
Less than 15 mins
Screw drivers
removed broken end caps, took a small screwdriver and simply applied a little pressure to release them. Pushed new end caps into place (they just snap in). Presto done!!
door shelf ends broken off from constant pulling on door and slaming it with 2 gallons of milk in door.
1 of 3 peoplefound this instruction helpful.
Katherine from Lafayette, LA
Really Easy
Less than 15 mins
Inserted the caps into the bar and snapped in door. That's it. No tools needed! Hope it last another 20 years
Was this helpful?
Thank you for voting!
light bilb went out
2 of 6 peoplefound this instruction helpful.
Denise from Landover, MD
Really Easy
Less than 15 mins
replaced it
Was this helpful?
Thank you for voting!
sheft ends brolen
0 of 1 peoplefound this instruction helpful.
Helen from Gulf Breeze, FL
Really Easy
Less than 15 mins
Cleaned and removed old ends, applied new ends and installed. Ends fit to order, shipping quick and parts affordable. Thank you
Was this helpful?
Thank you for voting!
door end cap broken,
0 of 1 peoplefound this instruction helpful.
Edward from Piscataway, NJ
Really Easy
Less than 15 mins
Put the new ordered door end caps in place, everything worked fine.
Was this helpful?
Thank you for voting!
clips on both end caps we broken and the crossbar kept falling off.
0 of 1 peoplefound this instruction helpful.
Frank from Orange Park, FL
Really Easy
Less than 15 mins
First i pulled the crossbar off the door, then I pulled both end caps off the crossbar and then I put the two new end cap on the crossbar and then tapped snoggly into place with the palm of my hand. Job done. took all of about 5 seconds.
Was this helpful?
Thank you for voting!
End caps broken
0 of 1 peoplefound this instruction helpful.
Russell from Clevelamd, TN
Really Easy
Less than 15 mins
End caps snapped out of door, Replaced with new caps
Was this helpful?
Thank you for voting!
Wrong size listed on website.
0 of 1 peoplefound this instruction helpful.
Elizabeth from Weems, VA
Really Easy
Less than 15 mins
The end cap is easy to remove and replace. The personnel at PartSelect was extremely helpful in re-ordering the correct part.
Was this helpful?
Thank you for voting!
Freezer door shelf end cap broke
0 of 1 peoplefound this instruction helpful.
Melanie from Green Bay, WY
Really Easy
Less than 15 mins
The only problem I had was that the end cap was sent before the rack. This refrigerator is in our cottage and I brought up the end cap while waiting to receive the rack. I couldn't remember where I put the end cap, so when the rack came it took me a few weekends to find the end cap. Once I did, it took me less than 1 minute to repair.
... Read moreI put the rack on the end caps & pushed the end cap in place. DONE!
frezzer iceing over and not cooling the refrigerator
1 of 4 peoplefound this instruction helpful.
Marcus from Pine Hill, AL
Really Easy
Less than 15 mins
Just removed the two screws and unpluged it. Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator. Thanks for the fast delevery. Will do busness with you in the future.
Was this helpful?
Thank you for voting!
The door end caps were broken and not fixable
0 of 1 peoplefound this instruction helpful.
Ryan from Coralville, IA
Really Easy
Less than 15 mins
I simply placed the retention bar between the new end caps and popped it into place. Took about 10 seconds to complete.
My Orders
