WRS322FDAM03 Whirlpool Refrigerator - Parts

For white, biscuit, black and stainless models.

This part releases water from the supply line when it's activated.

This screw is sold individually.

This kit includes the module motor, ejector arm, and ice stripper arm. The complete icemaker is sold separately.

This 2-plug LED light control board is a genuine OEM replacement part designed for refrigerators. It fits into the fresh food section of the refrigerator. The LED light helps users easily see the contents of the fridge, even in low-light conditions. LED lights are a popular choice due to their energy efficiency, longer lifespan, and abili...Read morety to produce bright and consistent lighting. Compared to traditional incandescent or fluorescent lights, LED lights consume less energy, generate less heat, and have a much longer operational lifespan, making them a preferred choice-

Sold individually.

Sold individually.

This ice auger support, also known as a baffle, is a manufacturer-approved replacement part for your refrigerator ice maker. This part can become cracked or damaged, preventing your ice auger from doing its job. This repair requires extensive disassembly; take photos as you go to make reassembly easier. To replace this part, life the ice ...Read moredoor out of the way and life the ice arm into the off position. Pull out the ice bucket and use a 1/4 inch nut driver to remove the screws holding the ice container and connecting rod in place. Pry the e-clip and washer off the bottom of the auger assembly. Use a 9/16ths wrench to remove the nut at the bottom of the auger. Pull off the auger teeth assembly and replace the auger support with your new part. Now you can begin reassembling.

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tra...Read morey can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

This part attaches to the drive shaft of the ice dispenser motor.

Sold Individually - Appliance originally takes 2.

Sold Individually. - * Part may differ in appearance, but functions same as original.